Belt Lubrication
To lubricate the belt, remove the rear end cap on both back corners of your treadmill and spray silicon lubricant onto the back side of the belt.
To remove the endcaps you will need to either lay the treadmill on its side or tip it forward onto the handlebars. Remove the phillips head screw, as shown in illustration A, and slide off both end caps.
Lay the treadmill back into an operating position and turn it onto 2MPH.
Using a silicon spray lubricant with a long nozzle extension, spray the inside of the belt from both sides for 5 seconds.
Replace the end caps and run the treadmill for 10 minutes at 5MPH.
a |
| b |
|
|
|
Cleaning
After use, wipe down your treadmill with a soft cloth. On a regular basis, you will also want to clean the treadmill using a mild detergent to remove all dirt and salt from the belt, painted parts and the display.
Avoid getting dirt and other materials on the belt as these materials can work their way under the belt and damage your treadmill or cause components to wear prematurely.
21