Spirit 350, XE150, 550 owner manual Handle BAR Assembly

Page 7

NOTE: there is one bolt already installed in the receiving bracket that will engage with the slot at the bottom of the console mast. This needs to be tightened at the end along with the three other console mast bolts.

5.Put the flat washer onto the 2 3/4” bolt and the two curved washers onto the two

1” bolts. Install, and hand tighten, the 2 3/4” bolt through the left side of the receiving tube into the console mast. NOTE: There is a wire running through the tube. Be careful not to damage or pinch this wire during this procedure. Damage to the electronic console could result. Install, and hand tighten, the two 1” bolts through the front of the receiving tube into the console mast.

6.Using the two sided wrench tighten the three bolts, and the fourth bolt which is pre-installed, firmly. These bolts should be tightened as much as you possibly can.

7.Locate the electronic console and the four 1/2” X 1/4” Phillips head screws.

8.There will be two electrical wire connectors at the top opening of the console mast, one 4 pin (hand pulse sensors), one 10 pin (main wire harness). Connect these to the mating connectors on the back of the console. The connectors are keyed so you cannot plug them in the wrong way so do not force them.

9.Storing the excess wire back into the console mast, carefully install the console onto the mounting plate and secure using the four Phillips head screws.

STEP 3: HANDLE BAR ASSEMBLY

1.Remove the hardware from the hardware pack for step 3. You should have two 5/8” X 3/8” bolts, two large flat washers, two large wave washers and four self tapping Phillips head screws.

2.Locate and install the 2 large wave washers onto the handle bar axle, one on each side.

3.Slide the left and right handle bars onto the appropriate side of the axle. There is a sticker on each handle bar indicating L for left and R for right.

4.Put the large flat washers onto the two 5/8” X 3/8” bolts and install, and tighten, in the threaded holes in the ends of the axle.

5.Install the plastic covers over the handle bar/axle connections with the six self tapping Phillips head screws.

STEP 4: FOOT PAD/CONNECTING ARM ASSEMBLY

1.Remove the hardware from the hardware pack for step 4. You should have two 1-1/4” X 3/8” bolts, two flat washers, two Nyloc® nuts, four 5/8” machine screws (long), four 3/8” machine screws (short) and two self tapping Phillips head

6

XE Series Elliptical

 

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Elliptical Table of Contents Product Registration Important Safety Instructions Important Operation Instructions Important Electrical InformationUnpacking the Unit Assembly InstructionsHandle BAR Assembly XE Series Elliptical XE150 Assembly drawing XE150.XE350.XE550XE Series Elliptical XE Series Elliptical XE350 XE Series Elliptical XE550 XE Series Elliptical Transportation FeaturesManual User Program Preset ProgramsTarget HR RecoveryGetting familiar with the control panel XE350 Console XE550 Console Basic information Power upProgramming the console Entering/Changing Settings Hill ProgramsFat Burn Strength CardioInterval Custom User Defined Programs XE Series Elliptical Rate of Perceived Exertion XE Series Elliptical Heart Rate Control Program 1 & 2 HR 1, HR 2 operation Using a Heart Rate TransmitterAuto-pilot XE550 only Elliptical Warranty Manufacturer’s Limited Warranty
Top Page Image Contents