1UPRIGHT Tube Assembly

1.Take the Left and Right upright tubes (part numbers 5 & 4) and slide the upright covers (99 & 100 right) onto the tubes (observe the cover orientation is correct). Connect the Middle Console Cable (38) that exits from the bottom of the right upright tube with the lower Console Cable (39). Insert the Left and Right (5 & 4) Uprights into the Left and Right Receiving Tubes (holes are on the outside of the tubes). Be careful not to pinch the wire when installing the upright.

NOTE: Partially tighten all bolts in this Step. This will allow for easier console assembly.

2.Attach the tubes with three Button Head Socket Bolts (93) from each side and two Button Head Socket Bolts (93) and two Curved Washers (94) from the front. Partially tighten using the Combination M5 Allen Wrench & Phillips Head Screw Drive (96).

HARDWARE

#93. 5/16” x 15mm	#94. 5/16” x 19 x 1.5T
Button Head Socket	Curved Washer
Bolt (8 pcs)	(2 pcs)

XT285 Treadmill