Motor Check, Elevation Calibration, Statistics

If the running belt is tracking to the right of the deck surface:

•turn the left bolt in a counter-clockwise direction to allow the belt to track to the left and ultimately in the center, or;

•turn the right bolt in a clockwise direction to allow the belt to track to the left and ultimately in the center.

NOTE – During any belt alignment procedure, do not turn each bolt by more than 1 to 1-1/2 revolutions. Exceeding this may cause a high amount of tension on the running belt and result in premature wear of the belt and rollers. It is best to adjust only one alignment bolt, since this will prevent the belt from excessive stretching resulting from adjustment of both alignment bolts.

5.To verify that the belt is properly aligned, slowly increase the speed to a maximum of 6.0 mph or 9.6 km/h, and let the belt turn for at least one minute. Carefully observe that the belt does not track to the left or right side. If the belt continues to track to one side, or you hear a rubbing noise, immediately press the CLEAR/STOP key to stop the belt. You will need to verify the alignment again.

6.Press the CLEAR/STOP key to terminate the test.

Motor Check

Motor check should only be performed if your computer needs to be changed or repaired, or if you feel that the speed is not working properly. The motor check procedure is automatic and does not require any tools.

1.In the Diagnostics menu, select the “MOTOR CHECK” and accept it by pressing the JustGoTM/ENTER key.

2.Press the JustGoTM/ENTER key to proceed.

3.Press the CLEAR/STOP key to terminate the test.

WARNING – Do not stand on the belt during this procedure.

Wait while the treadmill performs the motor check. That operation should take less than 30 seconds. Once completed, the message “MOTOR OK” will be displayed.

WARNING – If the motor check procedure is canceled prematurely, do not use the treadmill. It is important to fully complete the motor check procedure prior to using the treadmill.

Elevation Calibration

Elevation calibration should only be performed if your computer, your motor drive or your elevation motor need to be changed or repaired, or if you feel that the elevation is not working properly. The elevation calibration procedure is automatic and does not require any tools.

1.In the Diagnostics menu, select the “ELEVATION CALIBRATION” and accept it by pressing the JustGoTM/ENTER key.

2.Press the JustGoTM/ENTER key to proceed.

3.Press the CLEAR/STOP key to terminate the test.

WARNING – Do not stand on the belt during this procedure. The treadmill will elevate to a maximum of 15% incline.

Allow the treadmill to raise and lower automatically. The procedure will take approximately one minute to complete. If for any reason you must stop the test, press the CLEAR/STOP key to terminate the test.

WARNING – If the elevation calibration procedure is canceled prematurely, do not use the treadmill. It is important to fully complete elevation calibration procedure prior to using the treadmill.

Statistics

The statistics allow you to view different parameters related to the use of your treadmill such as time and distance.

1.In the Diagnostics menu, select the “STATISTICS” option and accept it by pressing the JustGoTM/ENTER key.

•The TOTAL TIME displayed indicates the amount of time the treadmill has been used during all exercise programs.

•The TOTAL DISTANCE displayed indicates the total distance traveled with the treadmill during all exercise programs.

2.Press the CLEAR/ STOP key to terminate the test.