Evo Fitness EVO 3I user manual Maintenance, HOW to Maintain the EVO 3i Treadmill

Page 18

18

EVO 3i MOTORIZED TREADMILL

MAINTENANCE

HOW TO MAINTAIN THE EVO 3i TREADMILL:

Proper maintenance is very important to ensure your treadmill is always in top working condition. Improper maintenance could cause damage or shorten the life of your treadmill and exceed the LIMITED WARRANTY coverage.

??Important: Never use abrasives or solvents to clean the treadmill. To prevent damage to the computer, keep liquids away and keep it out of direct sunlight.

??Inspect and tighten all parts of the treadmill regularly. Replace any worn parts immediately.

BELT ADJUSTMENT:

Belt adjustment and tension performs two functions: adjustment for tension and centering. The running belt has been adjusted properly at the factory. However transportation, uneven flooring or other unpredicted reasons could cause the belt to shift off center resulting in the belt rubbing with the plastic side rail or end caps and possibly causing damage. To adjust the belt back to it’s proper position please follow the directions below:

??Walking belt has shifted to the left: First unplug the power cord from the surge protector. Using the hex key provided, turn the left rear roller adjustment bolt 1/4 turn in the clockwise direction. Plug the power cord back into the surge protector and run the treadmill at 2.5 mph. You should see the belt start to correct itself, moving back towards the center. Repeat the above procedure until the walking belt is centered. It may be necessary to set walking belt tension once you have completed this procedure if the belt feels like it is slipping while walking. Refer below to the "Walking belt slipping" instructions.

??Walking belt has shifted to the right: First unplug the power cord from the surge protector. Using the hex key provided, turn the right rear roller adjustment bolt 1/4 turn in the clockwise direction. Plug the power cord back into the surge protector and run the treadmill at 2.5 mph. You should see the belt start to correct itself, moving back towards the center. Repeat the above procedure until the walking belt is centered. It may be necessary to set walking belt tension once you have completed this procedure if the belt feels like it is slipping while walking. Refer below to the "Walking belt slipping" instructions.

??Walking belt is slipping: First unplug the power cord from the surge protector. Using the hex key provided, turn both the left and right rear roller adjustment bolts the same distance, usually a 1/4 turn in the clockwise direction. Plug the power cord back into the surge protector and run the treadmill at 2.5 mph. You should now walk on the belt to determine if the belt is still slipping. Repeat the above procedure until the walking belt is not slipping. The tension should be just tight enough not to slip.

WARNING! Do not over tighten rollers! This will cause premature roller bearing failure!

Right and left tension bolts are located at the rear of the treadmill.

Visit us at: www.evofitness.com

Image 18
Contents EVO 3i Motorized Treadmill USER’S ManualPrecautions For future service or related questionsPrecautions Power Requirements Power RequirementsPreassembly Hardware Comparison Chart Hardware chartParts List Description Qty Order NoM6 x 20mm Screw Parts Diagram Parts Diagram Assembly StepAssembly Assembly Assembly Assembly Assembly How to transport the treadmill Transport InstructionsLevel Adjustment Maintenance HOW to Maintain the EVO 3i TreadmillCleaning To apply lubricant to the walking beltWarranty Conditions Of WarrantyImportant Steps Before beginningTarget Heart Rate Finding your pulseAerobic exercise Muscle Chart Targeted muscle groupsToe Touch Stretching RoutineWarm up and cool down Shoulder LiftSide Stretch Hamstring StretchInner Thigh Stretch Calf-Achilles StretchTreadmill looses power during use TroubleshootingTroubleshooting Treadmill will not start Treadmill walking belt slows during use888.800.1167