10. Attach the Crossbar (107) to the Handrails (82, | 10 |
|
|
|
83) with four #10 x 3/4" Screws (2) and four #10 |
|
|
| |
Star Washers (12). Do not tighten the Screws | First |
|
| 102 |
yet. | 212 | 9 |
| |
Insert the Console Frame (102) into the |
|
| ||
Handrails (82, 83). Attach the Console Frame |
|
|
|
|
with four 1/4" x 1" Screws (9). Do not tighten |
| 107 | First |
|
the Screws yet. Be careful not to pinch the |
|
| ||
Upright Wire (87). |
|
| 212 | 9 |
Tighten the two indicated #10 x 3/4"Screws | 82 |
| ||
first. Then, tighten the other two #10 x 3/4" |
|
| 87 | |
Screws (2). Do not overtighten the Screws or |
|
|
| |
use power tools. Next, tighten the four 1/4" x |
|
| 83 |
|
1" Screws (9). |
|
|
| |
11. Firmly tighten the four 5/16" x 1" Flat Head | 11 |
| Console | |
Screws (3) and the two 5/16" x 1" Bolts (4) (only | Console | |||
one side is shown). |
|
| Wire | |
With the help of a second person, hold the con- |
| Assembly |
|
|
sole assembly near the Right and Left Handrails | Console |
|
| 87 |
(83, not shown). |
|
| ||
Connect the Upright Wire (87) to the console | Wire |
|
|
|
wire. See the inset drawing. The connectors |
|
|
|
|
should slide together easily and snap into |
|
|
|
|
place. If they do not, turn one connector and try | 87 |
|
|
|
again. IF THE CONNECTORS ARE NOT CON- |
|
|
| |
NECTED PROPERLY, THE CONSOLE MAY | Wire |
|
|
|
BE DAMAGED WHEN YOU TURN ON THE |
| Ground Wire | ||
POWER. Remove the wire tie from the Upright | Tie |
| ||
Wire. | 4 |
|
| 109 |
Connect the Console Ground Wire (109) to the | 3 |
| 83 |
|
ground wire from the console assembly. |
|
| ||
| 11 |
|
|
|