Gold's Gym GGTL03607.3 Careful not to pinch the Upright Wire, Not fully tighten the Bolts yet

4. Hold a Bolt Spacer (79) inside the lower end of	4
the Right Upright (78). Insert an M10 x 96mm				5
Bolt (5) with an M10 Star Washer (8) into the
Right Upright and the Bolt Spacer. Repeat this		78
step with a second Bolt Spacer (79), M10 x
96mm Bolt (5), and M10 Star Washer (8).					8	77	79
Hold the Right Upright Spacer (80) and the
Right Upright (78) against the Base (85). Be
careful not to pinch the Upright Wire (77).
Partially tighten the M10 x 96mm Bolts (5); do					80 79		82
not fully tighten the Bolts yet.
Press a Base Endcap (82) into the Base (85).					85
5. With the help of a second person, carefully tip	5
the treadmill onto its right side. Partially fold the
Frame (48) so the treadmill is more stable; do
not fully fold the Frame yet.	81				48
Attach a Base Pad (81) to the Base (85) in the
location shown with an M4.2 x 25mm Tek Screw	2						27
(2) and a Base Pad Spacer (64). Then, attach
another Base Pad (81) with only an M4.2 x	85		64
25mm Tek Screw (2).
Attach a Wheel (86) to the Base (85) with an					86
M10 x 50mm Bolt (27) and an M10 Nut (33). Do			2	81		33
not overtighten the Nut; the Wheel must turn
freely.
6. With the help of a second person, hold a Bolt	6
Spacer (79) inside the lower end of the Left
Upright (73). Insert an M10 x 96mm Bolt (5) with						73
an M10 Star Washer (8) into the Left Upright		5	83
and the Bolt Spacer. Repeat this step with a
second Bolt Spacer (79), M10 x 96mm Bolt	79	8
(5), and M10 Star Washer (8).
Orient the Left Upright (73) and the Left Upright
Spacer (83) as shown. Hold the Left Upright	82	79
Spacer and the Left Upright against the Base
(85). Partially tighten the M10 x 96mm Bolts (5);		85
do not fully tighten the Bolts yet.
Press a Base Endcap (82) into the Base (85).
With the help of a second person, tip the tread-
mill so that the Base (85) is flat on the floor.
	8