PART | R0303A |
To locate the parts listed below, refer to the EXPLODED DRAWING attached in the center of this manual.
Key |
|
| Key |
|
| Key |
|
|
No. | Qty. | Description | No. | Qty. | Description | No. | Qty. | Description |
1 | 1 | Motor Hood | 43 | 1 | Right Foam Grip | 85 | 1 | Pulse Wire |
2 | 1 | Roller Ground Wire | 44 | 8 | Base Pad | 86 | 1 | Right Bottom Handgrip |
3 | 8 | Pivot Nut | 45 | 2 | Platform Screw (Rear) | 87 | 1 | Rear Roller |
4 | 1 | Motor Belt | 46 | 1 | Crossbar | 88 | 1 | Rear Foot (Right) |
5* | 1 | Motor Assembly | 47 | 4 | Screw | 89 | 1 | Motor Controller Wire |
6 | 1 | Flywheel | 48 | 1 | Filter Wire | 90 | 1 | iFIT.com Jack |
7 | 1 | Motor | 49 | 1 | Upright Wire | 91 | 2 | Rear Roller Adj. Bolt |
8 | 2 | Frame Spacer | 50 | 1 | Right Cup Holder | 92 | 2 | Roller Adj. Washer |
9 | 1 | Front Endcap (Left) | 51 | 1 | Frame | 93 | 1 | Rear Endcap (Right) |
10 | 1 | Front Roller Adj. Bolt | 52 | 1 | Incline Motor Bolt | 94 | 1 | Allen Wrench |
11 | 1 | Motor Pivot Bolt | 53 | 2 | Caution Decal | 95 | 1 | Rear Foot (Left) |
12 | 2 | Lift Frame Pivot Bolt | 54 | 4 | Pulse Sensor | 96 | 1 | Rear Endcap (Left) |
13 | 1 | Front Endcap (Right) | 55 | 2 | Extension Leg | 97 | 1 | Warning Decal |
14 | 1 | Motor Tension Nut | 56 | 2 | Wheel Bolt | 98 | 2 | Latch Plate Screw |
15 | 1 | Motor Washer | 57 | 2 | Roller Star Washer | 99 | 1 | Latch Plate |
16 | 1 | Motor Pivot Nut | 58 | 2 | Wheel | 100* | 2 | Extension Leg |
17 | 1 | Motor Tension Bolt | 59 | 1 | Incline Motor |
|
| Assembly |
18 | 1 | Reed Switch | 60 | 1 | Stop Bracket | 101 | 1 | Magnet |
19 | 1 | 2” Incline Motor Bolt | 61 | 1 | Power Cord | 102 | 1 | Belly Pan Clip |
20 | 1 | Reed Switch Clip | 62 | 1 | Grommet | 103 | 1 | Latch Spacer |
21 | 1 | Lift Frame | 63 | 2 | Static Decal | 104 | 1 | Console Ground Wire |
22 | 1 | Motor Star Washer | 64 | 1 | Upright | 105 | 2 | 1 3/4” Screw |
23 | 1 | Controller Bracket | 65 | 1 | On/Off Circuit Breaker | 106 | 2 | 1” Screw |
24 | 11 | 3/4” Screw | 66 | 1 | Audio Wire Nut | # | 1 | 4” Blue Wire, M/F |
25 | 1 | Controller | 67 | 2 | Crossbar Screw | # | 1 | 4” Blue Wire, 2F |
26 | 4 | Endcap Screw | 68 | 1 | Belly Pan | # | 1 | 4” Black Wire, M/F |
27 | 1 | Power Board | 69 | 1 | Audio Wire | # | 1 | 4” Black Wire, 2F |
28 | 1 | Plastic | 70 | 2 | Frame Pivot Bolt | # | 1 | 4” Red Wire, M/F |
29 | 1 | Power Board Bracket | 71 | 2 | Base Endcap | # | 1 | 8” White Wire, 2F |
30 | 1 | Key/Clip | 72 | 4 | Isolator | # | 1 | 14” Green Wire, F/R |
31 | 1 | Left Foam Grip | 73 | 2 | Belt Guide | # | 1 | User's Manual |
32 | 1 | Latch Assembly | 74 | 4 | Belt Guide Screw |
|
|
|
33 | 17 | 1/2” Screw | 75 | 4 | Platform Screw (Front) | # These parts are not illustrated | ||
34 | 2 | Handrail Extension | 76 | 2 | Foot Rail | * Includes all parts shown in the | ||
35 | 16 | 3/4” Tek Screw | 77 | 1 | Walking Belt | box |
|
|
36 | 1 | iFIT.com Wire | 78 | 1 | Front Roller/Pulley |
|
|
|
37 | 33 | Small Screw | 79 | 2 | Staple Cover | Note: Specifications are subject to | ||
38 | 1 | Console Base | 80 | 1 | Walking Platform | change without notice. For informa- | ||
39 | 1 | Left Cup Holder | 81 | 9 | 8” Cable Tie | tion about ordering replacement | ||
40 | 1 | Console Back | 82 | 1 | Left Bottom Handgrip | parts, see the back cover of the | ||
41 | 1 | Book Holder | 83 | 3 | Tie Holder Clamp | User’s Manual. | ||
42 | 1 | Console | 84 | 2 | Releasable Tie |
|
|
|