ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench
and your own phillips screwdriver 
.
1.With the help of a second person, carefully lay the treadmill on its right side as shown (refer to the drawing on page 4 to identify the right side).
Insert the Extension Legs (88) into the treadmill. Make sure that the Extension Legs are turned so the Base Pads (70) are on the indicated side. Attach each Extension Leg with an Extension Leg Screw (83).
With the help of a second person, carefully raise the treadmill to the upright position so the Extension Legs (88) are resting flat on the floor.
2.Refer to HOW TO LOWER THE TREADMILL FOR USE on page 11. Follow the instructions on page 11 to lower the treadmill.
Next, remove the nut, bolt, and shipping bracket from the left Upright (84).
3.Insert the brackets on the Console Base (56) into the Uprights (84); insert any slack in the Wire Harness (54) into the right Upright. Thread four Handrail Bolts (48) with Handrail Washers (47) into the Uprights. Tighten all four Handrail Bolts.
Make sure that the two indicated Grommets (89) are pressed into the holes.
1 | 83 |
|
|
|
|
| |
88 |
|
|
|
70 |
|
|
|
88 |
|
|
|
70 |
| 83 |
|
2 |
|
|
|
Shipping |
|
|
|
Bracket |
|
|
|
Bolt |
|
|
|
|
|
| Nut |
84 |
|
|
|
3 | 56 |
| Bracket |
|
| ||
Bracket |
|
|
|
47 |
| 47 | 89 |
|
| 54 | |
| 48 |
| |
|
|
| |
| 48 |
| 89 |
|
|
| |
| 84 |
|
|
5