2.Orient the Bench Frame (1) as shown. Orient the Front Stabilizer (2) with the square holes in the location shown.
Press two Stabilizer Caps (9) onto the Front Stabilizer (2). Attach the Front Stabilizer to the Bench Frame (1) with two M10 x 90mm Carriage Bolts (15) and two M10 Nylon Locknuts (13). Do not tighten the Nylon Locknuts yet.
3.Orient the Rear Stabilizer (3) with the warning decal on the indicated side. Press two Stabilizer Caps (9) onto the Rear Stabilizer.
Attach the Rear Stabilizer (3) to the Bench Frame
(1) with two M10 x 90mm Carriage Bolts (15) and two M10 Nylon Locknuts (13). Do not tighten the
Nylon Locknuts yet.
Make sure the Bench Frame (1) and the Front and Rear Stabilizers (2, 3) are level with the floor.
See steps 2 and 3. Tighten the M10 Nylon Locknuts (13) used in step 2 and 3.
2
| 13 | 1 |
|
| |
| 2 |
|
9 |
| 13 |
Square Hole
15
Square Hole |
| 9 |
|
|
|
3
315
9
13 
1
Warning
13 Decal 9
4.Attach the Seat Frame (4) to the Bench Frame
(1) with the four indicated M10 x 75mm Button Bolts (16) and four M10 Nylon Locknuts (13).
Note: It will be necessary to tip the weight bench on its side to tighten the Nylon Locknuts.
4 | 13 |
| 4 |
| 16 |
| 1 |
7