NordicTrack NTXC80181 user manual Problem The skis are slipping

Page 12

b. Roughen the surface of the resistance pad with 100-grit sandpaper. Oil the leather resistance pad with one or two drops of light household oil. Spread the oil over the resistance pad.

c. Oil the 3/8” washers and the thrust washer if needed.

PROBLEM: The flywheel and/or the resistance strap offers no resistance.

SOLUTION: a. Check the routing of the resistance strap.

b. Make sure the flywheel is tight. Remove the “U” bolt cover from the flywheel (see page 9). Evenly tighten the two 1/4” nuts located on the right side of the flywheel.

PROBLEM: The skis are slipping.

SOLUTION: a. Wipe off any excess oil.

b.Clean the bottom of the skis with a dry cloth or a small amount of mineral spirits or paint thinner.

c.Make sure that the flywheel is tight. Remove the “U” bolt cover from the flywheel (see page 9). Evenly tighten the two 1/4” nuts located on the right side of the flywheel.

PROBLEM: The rollers are squeaking or sticking.

SOLUTION: See GENERAL LUBRICATION on page 10.

12

Image 12
Contents Model No. NTXC80181 Customer HOT LineThis equipment. Save this manual For future referenceTable of Contents Important PrecautionsBefore YOU Begin Assembly Page HOW to Adjust the SKI Exerciser Battery Installation HOW to Operate the ConsoleDescription of the Console HOW to USE the SKI Exerciser Start with the LEG Motion onlyADD ARM Swings to the LEG Motion Combine the ARM and LEG Motions Maintenance and Storage Cleaning the SKI Exerciser Lubrication of the Resistance PAD Care for the Resistance Strap and FlywheelGeneral Lubrication Should not Be oiled. FollowStorage TROUBLE-SHOOTING Problem The arm cords are tangledProblem The skis are slipping Problem The rollers are squeaking or stickingConditioning Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencyPart LIST-M Odel NO. NTXC80181 Qty DescriptionExploded DRAWING-MODEL NO. NTXC80181 HOW to Order Replacement Parts Limited Warranty