English
Common Operations
Turning On and Off the Power
To turn on the unit, press 
so that the
STANDBY lamp goes off.
The Powered Rolling Panel opens automatically.
To turn off the unit (on standby), press 
again so that the STANDBY lamp lights up
The Powered Rolling Panel also closes.
A little power is always consumed even while the unit is on standby.
To switch off the unit completely, unplug the AC power
cord from the AC outlet.
When you unplug the AC power cord or if a power failure occurs
The clock is reset to “0:00” right away, while the tuner preset stations (see page 12) will be erased in a few days.
Setting the Clock
Before operating the unit any further, first set the
On the unit ONLY:
1 Press PANEL OPEN/CLOSE.
The unit is turned on and the Powered Rolling Panel opens automatically.
To check the clock time
Press DISPLAY while playing any source.
•Each time you press the button, the source indication and the clock time alternate on the display.
To adjust the clock again
If you have adjusted the clock before, you need to press CLOCK/TIMER repeatedly until the clock setting mode is selected.
•Each time you press the button, the clock/timer setting modes change as follows:
DAILY 
ON TIME 
REC
Canceled
Clock
ON TIME
setting
(The hour digits start flashing.)
If there is a power failure
The clock loses the setting and is reset to “0:00.” You need to set the clock again.
Setting the AM Tuner Interval Spacing
Some countries space AM stations 9 kHz apart, and some countries use 10 kHz spacing.
On the unit ONLY:
You can only change the AM tuner interval spacing while tuning into an AM station.
Press 
while holding down 7 
.
•Each time you press the button, the AM tuner interval spacing alternates between 9 kHz and 10 kHz.
2 Press CLOCK/TIMER.
The hour digits start flashing on the display.
3 Press 4 or ¢ to adjust the
hour, then press SET. | PREV |
•If you want to correct the hour after pressing SET, press CANCEL. The hour digits start flashing again.
4 Press 4 or ¢ to adjust the
minute, then press SET. | PREV |
|
NEXT
NEXT
Selecting the Sources
To listen to the FM/AM broadcasts, press FM/AM. (See
page 12.)
To play back CDs, press CD £¥8. (See pages 13 – 15.) To play back tapes, press TAPE 2 3. (See page 20.)
To select the external equipment as the source, press AUX.
SELECT
When you press the play button for a particular source (FM/ AM, CD £¥8, AUX, and TAPE 2 3), the unit turns on, and the Powered Rolling Panel opens automatically (and the unit starts playing the source if it is ready — COMPU PLAY CONTROL).
– 9 –