JVC CA-MXJ770V Using Recording Timer, When selecting CD, When selecting Tuner FM or Tuner AM

Page 28

English

Continued

6 When selecting “– CD – –”.

1) Press 4 or ¢ to select the disc number, then press SET.

2) Press 4 or ¢ to set the track number, then press SET.

PREVNEXT

Using Recording Timer

With Recording Timer, you can make a tape of a radio broadcast automatically.

The unit enters volume setting mode.

When selecting “TUNER FM” or “TUNER AM”.

Press 4 or ¢ to select the preset station number, then press SET.

The unit enters volume setting mode.

7 Press 4 or ¢ to set the

volume level.

PREV

NEXT

•You can select the volume level from

among the following — “VOL – –” ,“VOL 05”, “VOL 10” and “VOL 15”

If you select “ VOL – –” the volume is set to the last level before the unit was turned off.

8 Press SET to complete the Daily Timer setting.

The DAILY (Daily Timer) indicator stops

flashing and remains lit. The settings you have entered are shown on the display in sequence.

9 Press to turn off the unit (on standby) if you have set the Daily Timer with the unit turned on.

To turn on or off Daily Timer after its setting is done

1 Press CLOCK/TIMER repeatedly until “DAILY” appears on the display.

2 To turn off the Daily Timer, press

CANCEL.

The DAILY (Daily Timer) indicator goes off from the display (“OFF” appears for a while). The Daily Timer is canceled, but the setting for the Daily Timer remains in memory.

To turn on the Daily Timer, press SET.

The DAILY (Daily Timer) indicator lights up on the display. The settings you have entered are shown on the display in sequence for your confirmation.

If the unit is turned on when the timer-on time comes

Daily Timer does not work.

How Recording Timer works

The unit automatically turns on, tunes into the specified station, sets the volume level to “MIN,” and starts recording when the turn-on-time comes (the indicator flashes just before the turn-on-time, and continues flashing while the timer is operating). Then, when the turn-off-time comes (“OFF” appears just before the turn-off-time), the unit automatically turns off (stands by).

The timer setting remains in memory until you change it.

•There is a time limit for performing the following steps. If the setting is canceled before you finish, start from step 1 again.

•If you have made a mistake while setting the timer, press CANCEL. (However, this does not always work. If CANCEL does not work, press CLOCK/TIMER repeatedly and start from step 1 again.)

On the unit ONLY:

1 Put a recordable cassette into deck B.

2 Press CLOCK/TIMER until “REC” appears on the display.

The REC (Recording Timer) indicator also starts flashing on the display.

•Each time you press the button, the timer setting modes change as follows:

DAILY ON TIME REC

Canceled Clock ON TIME setting

(See page 9.)

3 Press CLOCK/TIMER again.

“ON TIME” appears for 2 seconds, then the unit enters turn-on-time setting mode.

– 27 –

Page 27 Page 29
Image 28
Page 27 Page 29
Contents CA-MXJ770V/CA-MXJ880V Introduction PrecautionsAbout This Manual Contents Location of the Buttons and Controls Front PanelPanel Front PanelPowered Rolling Panel Display WindowSee pages in the parentheses for details FM/AM button and lamp 9Remote Control Remote ControlConnecting Antennas Getting StartedUnpacking FM antennaConnecting Speakers Release the finger from the clampAM antenna To connect an outdoor AM antennaConnecting Other Equipment Adjusting the Voltage SelectorTo connect an analog component To connect a TV setTurning On and Off the Power Setting the ClockSetting the AM Tuner Interval Spacing Common OperationsAdjusting the Volume To turn down the volume level temporarilyReinforcing the Bass Sound Selecting the Sound ModesCreating Your Own Sound Mode Manual Mode To use your own sound modeSurround modes SEA Sound Effect Amplifier modesTuning in a Station Presetting StationsTuning in a Preset Station Listening to FM and AM BroadcastsPlaying Back Audio CDs Loading CDs Playing Back Several Discs ContinuousBasic CD Operations Press the same 0 you have pressed in stepOn the remote control Press the number buttons Program PlayLoad the CDs Program other tracks you wantTo check the program contents Repeating Tracks or CDs Repeat PlayProhibiting Disc Ejection Tray Lock To modify the programPlaying Back Video CDs/SVCDs Selecting Video Output PAL, MULTI, NtscLoading CDs Playing a Video CDBasic Concept of the PBC function You can view the pictures from the CD PlayerPress PBC on the unit after allowing Few seconds for the disc to be readSpecial Plays for a Video CD Resuming PlayUsing Subtitles Playing a Multiplex Sound CDViewing the Highlights of a Video CD OperationPlaying Back Tapes Playing Back a TapeLocating the Beginning of a Song Music Scan Press Eject 0 for the deck you want to useTo clean the heads, capstans, and pinch rollers To record on both sides Reverse ModeRecording Recording a Tape on Deck BDubbing Tapes Press DubbingTo record an AM station Beat Cut To stop during dubbing, pressAuto Edit Recording On the unit only Load CDsPress Edit Press SETUsing the Microphones Singing AlongSinging Along with Multiplex Karaoke Discs MPX To apply an echo to your voiceRecording Your Singing Microphone mixingUsing the Timers Using Daily TimerUsing Recording Timer When selecting CDWhen selecting Tuner FM or Tuner AM Press SET to complete the Daily Timer settingUsing Sleep Timer Timer PriorityMaintenance To clean the discHandling discs Handling cassette tapesTroubleshooting SymptomSpecifications Page Important for mains AC line
Top Page Image Contents