Bodysmith WORKOUTCENTER. Assembly Instructions

807 BODYSMITH WORKOUTCENTER. ASSEMBLY INSTRUCTIONS

".~!~,:~::.'..'.;:., 5 ,. ..

'; ::::THE~+;8OT"'iBODYSMITHWORK FACE.TO ASSURE ITS PRI

Attach eight (8) PARAGLIDESTRIPS to the WOLFFSLEEVE(FOUR ONEACHEND) as shown (DETAILA) using the follo~ving steps:

¯Thoroughly clean all surfaces where the PARAGLIDESTRIPSare to be attached.

¯Removethe PARAGLIDESTRIPSfrom the paper backing and firmly apply them to all shown surfaces.

Insert one (1) U-PIN through the BUSHINGof the WOLFFSLEEVEand one (1) U-PIN through BUSHINGof the BENCHFRAMEas shown on drawing, and attach t~vo (2) PALNUTSto the ends the U-PINS.

SECURELYAssemble three (3) SPRING PIN ASSEMBLIESto the SPRINGPIN HOUSINGS,two (2) on the UPRIGHTTUBES. and one (1) on the WOLFFSLEEVEas shown in (DETAIL

(!!! IMPORTANT~! TIGHTEN THE NUT OF THE SPRING PIN ASSEMBLYSECURELY)

Pull back the SPRINGPIN on the WOLFFSLEEVEand slide it over the end of the BENCHFRAMEas shown on dra~ving. Engage the SPRINGPIN into one of the adjustment holes. Secure the WOLFF SLEEVEin place with one (11 THUMBSCREW.

Insert two (2) 2 IN. SQ. ENDCAPSinto both ends of the BASELEGas sho~vn o~ drawing.

Insert the BASELEGinto the fi'ont of the BENCHFRAMEas shown on drawing. (MAKESURE THAT THE TAB ON THE BA.SE LEG IS UNDER THE BENCH FRAME)

Insert four ~4) 2 IN. SQ. ENDCAPSinto the BASETUBESof the UPRIGHTFRAMEa:; sho~vn on dl'aWin ~