ParaBody LP5 manual Step

For assembly to the GS1, GS2, GS4, GS8 Gym Systems .

4

Make sure MAIN ARM 9−1/2" is orientated correctly

5

16

15

13 1

FIGURE 1 12 1/2 X 4-3/4”

STEP 1:

•NOTE: Follow STEP 1 for the assembly of the LEG PRESS to the GS1, GS2, GS4 and GS8 Gym Systems. If you have the CM3 or GS6 Gym System proceed to STEP 2.

•NOTE: FLANGE BEARINGS SHOULD BE PRE-INSTALLED

•SECURELY assemble the SECOND ARM (5) to the FRAME (1) using one 1/2 X 4-3/4” BOLT (12), one 3/4 X 4” SHAFT (15)

and one 1/2” LOCK NUT (13). See FIGURE 1.

•SECURELY assemble the MAINARM (4) to the FRAME (1) using one 1/2 X 4-3/4” BOLT (12), two 3/4” FLANGE BEARINGS (14), one 3/4 X 4” SHAFT (15) and one 1/2” LOCK NUT (13). See FIGURE 1. (NOTE: Make sure MAINARM is orientated correctly, top hole should be 9-1/2” from the top of arm as shown in FIGURE 1.)

•SECURELY assemble two 1-1/2 X 2 “ BUMPERS (16) to each side of the MAINARM (4) where the MAINARM (4) contacts the FRAME

(1) See FIGURE 1.

•Proceed to to STEP 3.

	1/2		1/2		1/2		1/2		1/2		1/2
0		1		2		3		4		5	6

5