125992691.qxd 26/05/2004 11:13 Pagina 13
Something Not Working
Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. Before contacting your local Service Centre, please carry out the checks listed below.
IMPORTANT: if the END light flashes, the buzzer sounds and an alarm code is displayed, switch the machine off and call the Service Centre.
Symptom | Possible causes |
|
|
The tumble dryer does not | ● The door(s) has (have) not been closed. |
start | ● The plug is not properly inserted in the power socket. |
| ● There is no current at the socket. |
| ● The main fuse or the fuse in the plug has blown. |
| ● The selector dial is not set correctly. |
| ● The water reservoir is full or not properly inserted (the FULL TANK light is on). |
| The programme starts in any case but it stops after approx. 4 minutes. |
| ● The START/PAUSE Button has not been depressed. |
| ● The DELAY START option has not been selected. |
|
|
Drying takes too long or | ● The laundry has not been spun properly. |
laundry is not dry enough. | ● The filters and/or the condenser are clogged up. |
| ● The water reservoir is full. |
| ● The room temperature is too high. |
| ● The selected time or drying cycle was not suitable for the laundry. |
| ● The LOW TEMPERATURE button has been pressed. |
| ● There is too much laundry inside the appliance. |
| ● The dryer is not correctly installed. |
|
|
The drum light does not | ● The Programme/Time selector dial is on position “RESET/OFF”. |
light up: | ● The lamp is defective. |
|
|
If after the above checks, there is still a fault, call your local Service Force Centre.
13
