358 EX350 ASSEMBLY INSTRUCTIONS
53.SECURELYassemble the BACKPADto MAINUPRIGHTusing two (2) 3/8 X 3 IN. FlEX HEAD BOLTS and two (2) 3:8 IN. LOCKWASHERS.(HIDEM WELTCLIP SHOULDBE FACING DOWN)
54.¯ To assemble the PECDECLOOPCABLE,start by LOOSELYattaching each end of the CABLEto CAMSof the LEFT and RIGHTPEC DEC ARMS,using two (2) 5116 X I IN. HEXHEAD
BOLTS.four(4) 5 "16 IN. WASHERStwo. (2) 5/16 IN. LOCKWASHERSand. two I'.2) 5/16
NUTS. (SEE DETAIL C)
¯Rut1 CABLEback to the PULLEYSon the PULLEYBRACKETSUPPORT. Drape the CABLE over the PULLEYSo,a both sides. Position the CABLERETAININGCLIPSover the top of the
CABLEat a
DETAIL A)
¯LOOSELYassemble one (I)
CABLERETAINING"L" CLIP, and one (I) .~/8 IN. LOCKNUT.
¯Assemble the CENTERPULLEYBRACKETASSEMBLYover the LOOP CABLEas Sh.o~vn on drawing. Position the CABLERETAININGCLIP under the CABLE.(SEE DETAILA)
Tiahten all LOOSEPULLEYand CABLEconnecttons.
Attach the end ofone { i ~ 21 LINKCHAINto the CENTERPULLEYBRACKETusing one (1) 5/16 IN.
SNAP LINK. (SEE DETAIL B)
Attach the other end of the CHAINto the end of the CABLEin the LOWROWSWIVELBRACKETon "the MAIN.UNIT using one (I) QUICKLINK.
TIGHTEN ALL BOLT CONNECTIONS AT THIS ThME. (NOTE: IF PRESS ARM APPEARS TO
BE OFF CENTER.ALIGN PULLEYS WITH STOP ON .BACK SEAT SUPPORT BEFORE AND DURING TIGHTENING)
*** REFER TO ASSEMBLYDRAWING#3 FOR STEPS 59 THRU 67 ***
¯Attach LAT BARto PRIMARYCABLEwith one (1) 5:16 IN. SNAPLINK (SEE DETAIL
¯Attach one I I ) "; 16 IN. SNAPLINKtoeach end of the second 21 LINKCHAINto l~e used with
eitherthe LOWROWPULLEYon the LEG CURL ARMASSEMBLYor the UPPER PULLEY.
¯NOTE: SEE TH E EXERCISE WALL CHART FOR INEORMATION ON THE VARIOUS ACCESSORi ES THAT ATTACHTO THE 5/16 IN. SNAP LINKS.
60.AttaCh eight (8~ PARAGLIDESTP, IPS to the SEAT SUPPORTTUBEon the BACKSEATSUPPORT. as sho~n in (DETAI L H) using the tbllowing steps:
,Tlaoroughl.~ cle;m all inside surfaces ~here the PARA~LID~strip~- are to be attached.
Remox the paper
10