ParaBody 897101 manual Supports RUN Underneaththe Cable Inside of the TOP Boom, Boom Weldment

897101 WEIGHT STACK OPTION ASSEMBLY INSTRUCTIONS

Insert two (21) GUIDERODBUSHINGSinto the ROUNDTUBESof the PULLEYHOUSING WELDMEI~[Tas shown. Also insert one (1) 1-3/4 IN SQENDCAPinto the top of the PULLEY HOUSING WELDMENT.

10.Tilt the GUIDERODSback up to vertical. Insert the PULLEYHOUSINGWELDMENTinto the UPRIGHTF]~LAMEWELDMENTof the PROSYSTEMwhile at the same time insert the GUIDERODS into the GLr[DE RODBUSHINGSof the PULLEYHOUSINGWELDMENTas shown.

ll.Route the WEIGHTSTACKCABLEthrough the front slot and downto the rear slot of the TOP BOOMWELDMENTLOOSELY.Re-assemble the three (3) 3-1/2 X 1 IN. PULLEYSto the TOP BOOMWELDMENT. (NOTE: MAKE SURE CABLE IS IN THE GROOVE OF THE FIRST TWO PULLEYS ONLY).

12.SECURELYre-assemble the TOP BOOMWELDMENTto the PROSYSTEMthe same way it was removed using the existing hardware. (MAKESURETHATTHEBOLTSOF THE ][lOOM

SUPPORTS RUN UNDERNEATHTHE CABLE INSIDE OF THE TOP BOOM)

13.LOOSELYassemble two (2) 3-1/2 X 1 IN PULLEYSto the PULLEYHOUSINGWELI~tMENT shown.

14.WEIGHT STACK CABLE ROUTING (SEE CABLE ROUTING DIAGRAM) (NOTE: SOME PULLEYS MAYHAVE TO BE REMOVEDAND REASSEMBLEDIN OI~J)ER TO ROUTE THE CABLE.

Co

Eo

Route the threaded end of the WEIGHTSTACKCABLEunder, and around the top 3-1/2 X 1

IN.PULLEYofthePULLEYBLOCK,andbackup throughthelargeholeontopof theTOP

BOOM WELDMENT.

Route the CABLEthrough the hole and over and around the two PULLEYSin the PULLEY HOUSINGWELDMENTRun. the cable down through the large hole above the WEIGHT STACKand down to the WEIGHTSTACKSHAFTofthc HEADPLATE.

Thread the end ofthc CABLEinto the end of the WEIGHTSTACKSHAFT.

Insert the 3 X 2 IN. ENDCAPSinto the ends of the PULLEYHOUSINGWELDMENTas shown on drawing.

SECURELYtighten all loose pulley connections.

15.Re-attach LAT BARWELDMENTto the HIGH PULLEYCABLE.

16.Attach the WEIGHTSTACKLABELSto the WEIGHTSTACKas shown in (DETAIL A).

17.To select WEIGHT,rotate the WEIGHTSTACKSELECTORPIN clock wise 90 degrees, insert into the slot of the desired WEIGHTPLATE,and rotate the PIN back down.

Part Number 6660001 4 12/30/96