4.Insert two LINEAR BEARINGS (12) into the ends of the RIGHT CARRIAGE (15), secure the LINEAR BEARINGS with one SNAP RING (14) at each bearing.
NOTE: Leave the cardboard sleeve in the bottom LINEAR BEARING, remove the cardboard sleeve from top bearing.
Repeat the procedure on the LEFT CARRIAGE (13).
5.Assemble the CARRIAGES (13 & 15) to the LIFT BAR (16) and as shown. Make sure the LIFT BAR is inserted completely through both roller bear- ings located within the CARRIAGE TUBES (B).
14
12
15
12
14
15
13
16
B