Signature Smith Machine
Assembly Instructions
BE SURE TO SELECT A LEVEL LOCATION FOR ASSEMBLY. THE SIGNATURE SMITH MACHINE MUST REST LEVEL AND IN COMPLETE CONTACT WITH THE FLOOR.
1.With the help of another person, erect the LEFT and RIGHT SIDE FRAMES (1 & 2). Position the SIDE FRAMES approximately 50 inches between the inside flat sections of the LIFT BAR RACKS (A) for ease of assembly.
2.From the side, loosely assemble BACK BRACE (3) to the LEFT SIDE FRAME (1) using three M10 x 130mm BOLTS (4), three 3/8" SAE WASH- ERS (5), three 1/4" SPACERS (6) and three M10 x SOCKET HEAD NUTS
(7). From the back, install three M10 X 25mm BOLTS (8), six 3/8" SAE WASHERS (5) and three M10 HEX NYLOCK NUTS (10). Finger tighten the BOLTS and NUTS only.
Repeat the procedure to assemble the BACK BRACE (3) to the RIGHT SIDE FRAME (2).
3.Loosely assemble the FRONT BRACE (11) to the LEFT and RIGHT SIDE FRAMES (1 & 2) using four M10 X 130mm BOLTS (4), four 3/8” SAE WASHERS (5), four 1/4" SPACERS (6), and four M10 SOCKET HEAD NUTS (7).
11 | 7 | 6 |
5 8
3
5 4
2
1
7 6
5
10