Kit No. | 08 Sep 2008 |
Document No. |
9.The kit contains Oilite washers in two thicknesses. Slip one of the thinner Oilite washers onto the deadshaft as shown in Figure 6.
10.Wipe the deadshaft with the supplied alcohol wipe. Save the wipe; it will be used later in this procedure and during the second rocker arm installation.
Fig 6: Installing the Oilite washer
11.Apply a bead of green Loctite #620 thread locking compound from the supplied applicator tube all the way around the deadshaft, about an inch (3 cm) from the end (see Figure 7). Do not use more than half of the compound in the tube.
Fig 7: applying Loctite to the deadshaft
12.Apply the remaining Loctite around the inner surface of the rocker arm sleeve (see Figure 8). Keep the compound at least an inch (3 cm) from the edge of the sleeve to avoid getting any compound on the new bearings.
Fig 8: applying Loctite to the rocker arm
3