Kit No. | 08 Sep 2008 |
Document No. |
13.Rotate the rocker arm back and forth while sliding it onto the deadshaft (see Figure 9). This will spread the Loctite evenly onto the deadshaft.
14.Wipe off any excess Loctite near the snap ring groove with the alcohol wipe.
Fig 9: installing the rocker arm
15. Install one of the thicker Oilite washers.
Fig 10: installing the Oilite washer
16.Install the new thrust washer onto the sleeve next to the snap ring groove (see Figure 11).
Fig 11: installing the thrust washer
4