Life Fitness 849 manual Perform the following to all three Weght Stacks

Page 33

FIGURE 42

LEG CABLE 43

50

53

STEP 42:

•Screw the threaded end of the LEG CABLE (43) approximately 1” into the end of the SELECTOR SHAFT (50) of the HEAD PLATE (53) as shown in FIGURE 42.

STEP 43:

53

• Perform the following to all three WEGHT STACKS:

• Insert one WEIGHT STACK PIN (75) into each weight stack on the 8500

106

GYM as shown in FIGURE 43.

 

• If upon completion of assembly, the HEAD PLATE (53) does not sit on top

 

of the first WEIGHT PLATE (106), push the HEAD PLATE (53) down,

 

insert the WEIGHT STACK PIN (75) and perform several repetitions at the

 

press station. This will relax the cable system and prevent the HEAD

 

PLATE (53) from lifting up.

 

• If after completing previous step, the HEAD PLATE (53) still does not sit

 

on top of the first WEIGHT PLATE (106) or if there is excess slack in the

75

cable system, adjust the threaded end of the CABLE accordingly and

 

retighten the jam nuts.

 

• If there is excess slack in the AB or PEC DEC cable system, adjust the

 

threaded end of the AB CABLE (45) accordingly and retighten the jam

 

nut.

 

 

FIGURE 43

33

 

Page 32 Page 34
Image 33
Page 32 Page 34
Contents 8500 3-STACK MULTI-GYM Important Notes Parts List Step Step LOW LOW Height Step 86 1/2 LOW Height 94 1/2 X 115 3/8 X 3 Counter Sunk 101 91 3/8 X 3-1/4 Step 94 1/2 X Step Same Time 103 Button Head As shown in Figure 95 1/2 X 3-1/4 Page LAT Cable It in the the slot Cable PEC Cable Detail Press Cable ING Bolt Press LEG Cable X 2 Into the slot Perform the following to all three Weght Stacks 111 110
Top Page Image Contents