3/8" X 1"
STEP3:
A. Insert the two GUIDERODS(2) into the base the TOWERas shown in FIGURE3. Lubricate the GUIDERODSwith a slicon or teflon spray that is available at most hardware stores.
B. Slide two WEIGHTSTACKCUSHIONS(6) down over the GUIDERODS(2). See FIGURE
C. Using EXTREMECARE slide twenty WEIGHT PLATES(5) down over the GUIDERODS(2)
the "PARABODY"side up and the
rOWER
Do | Securely assemble the WEIGHTSTACKSHAFT |
|
|
| |
| (1) to the HEADPLATE(3) using one 3/8 |
|
| BUTTONHEADC.AP SCREW(9) and one 3/8" |
|
| LOCKWASHER(10). (Note: The bolt hole |
|
| the HEADPLATE(3) should be on top.) |
|
| Carefully Slide the HEADPLATE ASSEMBLY |
|
| (1 & 3) down over the GUIDERODS(2) onto |
|
| weight stack as shown in FIGURE3. | FIGURE 3 |
|
|
TOWER
BRACE
]FIGURE 4
STEP 4:
Insert two GUIDERODBUSHINGS(8) into the holes in the TOWERBRACE.See FIGURE