812INNER/OUTER THIGH MACHINE. ASSEMBLYINSTRUCTIONS
8.Insert two (2) 2 IN. SQ. ENDCAPSinto both ends of the BEARINGHOUSINGas shown on drawing.
9.SECURELYassemble the BEARINGHOUSINGto the BASEusing two (2) 3/8 X 3 IN BOLTS, four
(4)3/8 IN WASHERS,and two (2) 3/8 IN. LOCKNUTS.
10.Insert two (2) 2 IN. SQ. ENDCAPSinto both ends of the PULLEYMOUNTas shown on &rowing.
11.SECURELYassemble the the PULLEYMOUNTto the BASEas shown on drawing, using two (2) 318 X 3 IN. BOLTS,four (4) 3/8 IN. WASHERS,and two (2) 3/8 IN. LOCKNUTS. (MAKESURE PULLEY MOUNTIS ATTAClqT~D AS IT IS SHOWNIN THE DRAWING)
12.SECURELYassemble two (2) SPRINGPIN ASSEMBLIESto the ARMSas shown in CI)E~AIL A).
13.Insert four (4) 3/4 IN. FLANGEBEARINGSinto the BUSHINGSof the ARMS.
14.Insert the shaft of each SWIVELARMthrough the 3/4 IN. FLANGEBEARINGSon the ARMSas shown on drawing, and SECUREin place with two (2) 3/4 IN. STAR_LOCKCOLLARS.
15.Insert two (2) 2 IN. SQ. ENDCAPSinto the ends of the ARMS,as shownon drawing.
16.Insert four (4) 3/4 IN. FLANGEBEARINGSinto the BUSHINGSof the BEARINGHOUSI~G.
17.Assemble the ARMSto the BEARINGHOUSING,using the following steps:
Carefully tip the BASEon its side.
Slide one (1) 3/4 IN. THRUSTWASHERand one (1) ROTARYPLATEonto the shaft of each
Attach each ARMto the BEARINGHOUSINGand SECUREin place with two (2) 3/4 ~q. STAR LOCK COLLARS.
18.SECURELYattach the LEFTand RIGHTtIANDLESto the BASEusing two (2) 3/8 x
19.Slide two (2) 1 X 5 IN. GRI~S over the LEFT and RIGHTHANDLES(IF. A LUBRICAN~I REQUIRED, COAT ~ INSIDE OF THE GRI~ WITH RUBBING ALCOHOL)
20.SECUREthe SEATPADto the LEFT and RIGHTHANDLESusing two (2) 3/8 X
21.SECUREthe BACKPAD to the CARRIAGEUPRIGHTusing two (2) 3/8 X
(2)3/8 IN. LOCKWASHERS,and two (2) 3/8 IN. WASHERS.
22.SECURELYattach four (4)
(4)3/8 IN. LOCKNUTS.
PART#6656601 | 5 | REVISION10/21/96 |