FIGURE 7
IMPORTANT: Cable must run
in all the pulley grooves.
;TEP7
Install the NEWPRIMARYCABLE(13) using the following steps:
¯Route the CABLE(13) through the TOPBOOMas sho~a in FIGURE7. The pulleys in TOPBOOMmayneed to be temporarily removed to perform this step. (Note: Makesure the CABLEis running in all the pulley grooves.)
Route the CABLE(13) around the FLOATINGPULLEYBRACKETas shown in FIGURE
Route the CABLE(13) back over one pulley in the GUIDERODSUPPORT,downthrough the PULLEYE;RACKET(2) and over second pulley in the GUIDERODSUPPORT.
Screw the threaded end of CABLE(13) into the HEADPLATEASSEMBLY.
I | 1/2 | ~ | 1/2 | I | 1/2 | ~ | 1/2 |
6