ADJUST!
~ SPRIG PIN ADJUSTMENT
FIGURE14
STEP 14
¯The 832 LEGPRESSis equippedwith a spring pin adjustment to accommodatedifferent sized users and allew eas)" entry and e,,dt from the machine.To use, you mustslightly push against the foot plates to take tension offthe pin.
¯To set the correct amountof tension in the cables, adjust the 832LEGPRESSinto the last adjustmenthole (sc, the LEGPRESSis spread apart) and remove the WEIGHTSTACKPIN. Thread the PRIMARYCABLE(i 3) into the HEADPLA'IE AS SEM]BLYuntil both PULLEYBRACKETS(2) are held against the TOPBOOMand the cable is slightly pulling up on the HEAl)PLATETighten. the
but securely. Next, thread the LEGPRESSCABLE(14) into the PULLEYBRACKET(2) until cable is tight, then tighten the jam securely.
¯If further adjustment is needed, lossen and adjust the pulley attached to the slotted tab on the BENCHFRAME(NOTE:.It is natural for the LEGPRESSCABLEto slacken whenseat is adjusted inward.)
Thank you for purchasing the Parabody 360101 Leg Press Adapter Kit. If unsure of proper use of equipment,
call your local Parabody distributor or call the Parabody customer service department at (800)
11