Image IMBE41990 manual

Page 13

23.Turn the Seat (14) as shown. Attach the wide end of the Seat to the bracket on the Seat Support Tube (37) with two M6 x 16mm Screws (3).

Tilt the Seat Support Tube (37) upwards and attach the narrow end of the Seat (14) to the Seat Support Tube with an M6 x 38mm Bolt (60) and an M6 Washer (30).

23

14

37

30

3

60

24.Make sure that all parts are properly tightened before you use the weight bench. The use of all remaining parts will be explained in ADJUSTING THE WEIGHT BENCH starting on the following page.

13

Image 13
Contents Mon.ÐFri., 6 a.m.Ð6 p.m. MST Model No. IMBE41990 Serial NoTable of Contents Important Precautions Right Side Before You BeginLeft Side Part Identification ChartÑModel No. IMBE41990 R1299A Some small parts may be pre-assembled AssemblyDo not tighten the Nylon Locknuts yet Nylon Locknuts yet Page Locknut yet Guide away from the Upright 1 as you insert itTighten all of the Nylon Locknuts used in steps 1 to Page Locknut the Seat Support Tube must pivot easily Nylon Locknut the Seat Adjustment Bracket must pivot easilyPage Using the Locking BAR and Safety Spotters Adjusting the Weight BenchAdjusting the Backrest Qty Description Part ListÑModel No. IMBE41990Exploded DrawingÑModel No. IMBE41990 Limited Warranty Ordering Replacement PartsIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT