Image IMBE41990 manual Adjusting the Weight Bench, Using the Locking BAR and Safety Spotters

Page 14

Adjusting the Weight Bench

This section explains how the weight bench is adjusted. See the included exercise guide for important informa- tion about how to perform a variety of exercises and how to get the greatest benefit from your exercise program.

Inspect and tighten all parts each time you use the weight bench. Replace any worn parts immediately. The weight bench can be cleaned with a damp cloth and a mild, non-abrasive detergent. Do not use solvents.

USING THE LOCKING BAR AND SAFETY SPOTTERS

Before starting an exercise, position the barbell and the Safety Spotters (23, 24) in the correct position for that exercise.

To do this, stand in front of the cage and grip the Locking Bar (34) with both hands. Turn the Locking Bar until the two hooks disengage the slots in the Uprights (1). Move the Locking Bar to a new position and turn the Locking Bar until the hooks engage the slots in the Uprights.

Note: Always start an exercise with the barbell posi- tioned at the lowest point to which it will move during the exercise.

Position both Safety Spotters (23, 24) directly under the Weight Gliders (31, 32).

USING THE SAFETY SPOTTERS

To move a Safety Spotter (23, 24 [not shown]) to a new position, grip the handle on one side of the Spotter Hook (61, 62 [not shown]) and pull the Spotter Hook out of the slot in the Upright (1). Raise or lower the Safety Spotter to a new position and turn the Spotter Hook until it engages one of the slots in the Upright.

WARNING: Always set both safety spotters at the same height.

ATTACHING WEIGHTS TO THE BARBELL

To use the Barbell (35), slide the desired amount of weight (not included) onto each end of the Barbell. Secure the weights with the Large Weight Clips (13).

Note: To use standard weights, the Weight Adapters (33) should be removed from the Barbell (35). Attach weights to the Barbell with the Small Weight Clips (not shown).

WARNING: Do not place more than 260 pounds on the barbell. Always secure the weights with weight clips when they are on the barbell. Always place the same amount of weight on each side of the barbell.

1

1

31

23

34

32

24

1

61

23

Handle

33

35

13

14

Image 14
Contents Model No. IMBE41990 Serial No Mon.ÐFri., 6 a.m.Ð6 p.m. MSTTable of Contents Important Precautions Left Side Before You BeginRight Side Part Identification ChartÑModel No. IMBE41990 R1299A Do not tighten the Nylon Locknuts yet AssemblySome small parts may be pre-assembled Nylon Locknuts yet Page Guide away from the Upright 1 as you insert it Locknut yetTighten all of the Nylon Locknuts used in steps 1 to Page Nylon Locknut the Seat Adjustment Bracket must pivot easily Locknut the Seat Support Tube must pivot easilyPage Adjusting the Weight Bench Using the Locking BAR and Safety SpottersAdjusting the Backrest Part ListÑModel No. IMBE41990 Qty DescriptionExploded DrawingÑModel No. IMBE41990 Icon Health & FITNESS, INC., 1500 S W., LOGAN, UT Ordering Replacement PartsLimited Warranty