3.Attach one of the Front Uprights (1) to the Lower Support Plates (13) on the Right Base (7) with two 3/8Ó x 3 1/2Ó Bolts (6) and two 3/8Ó Nylon Locknuts (11). Do not tighten the Nylon Locknuts yet.
Note: The Front Upright will slant backward slightly.
Be sure that the holes in the Front Upright (1) line up with the holes in the Support Plates (13). If they do not line up, turn the Front Upright over.
Attach the other Front Upright (1) to the Left Base (2, not shown) in the same manner.
3
1
6
13
7
11
4.Press four Weight Rest Bushings (17) into the top and bottom of a Short Weight Rest (4) and a Long Weight Rest (19), as shown. Pull the Adjustment Knob (12) on the Long Weight Rest and slide the Long Weight Rest onto one of the Front Uprights
(1).Hold the Long Weight Rest at the desired
height and turn the Adjustment Knob clockwise to tighten it into one of the adjustment holes in the Front Upright.
Pull the Adjustment Knob (12) on the Short Weight Rest (4) and slide the Short Weight Rest onto the Front Upright (1). Hold the Short Weight Rest at the desired height and turn the Adjustment Knob clock- wise to tighten it into one of the adjustment holes in the Front Upright.
Attach the other Short Weight Rest (4) and Long Weight Rest (19) to the other Front Upright (1) in the same way. Make sure that both Short Weight
Rests and both Long Weight Rests are at the same height.
5.Press a 2 1/2Ó Square Inner Cap (9) into one of the Front Uprights (1). Attach two Upper Support Plates
(3)to the Front Upright with two 3/8Ó x 3 1/2Ó Bolts
(6)and two 3/8Ó Nylon Locknuts (11). Do not tight- en the Nylon Locknuts yet.
Repeat this step with the other Front Upright (1, not shown).
4
17
12
4
17
19 
12
17
Adjustment
1
Holes
5 | 9 |
|
3
11
3
1
6
6