Assembly
NOTE: Hand tighten bolts and nylon nuts until machine is fully assembled.
STEP 4
Notice:
The cable diagram below shows the proper routings of the 110”Lat Cable (#20), the 92” Low Row Cable (#16) for the cable assembly in Steps 4 Use the diagram to be sure that the two cables have been assembled correctly. If the cables have not been correctly rout- ed, the Machine will not function properly and damage may occur.
Draw the end, without the rubber ball, of the 110”Lat Cable (#20) to the open bracket at the front of the Upper Frame (#19). Install a Pulley (#32). Secure it with one M10 ×45 Hex Bolt (#34), two Washers Dia10 (#39) and one M10 Nylon Nut (#38).
Draw the Cable along the Upper Frame towards the back of the machine to the first open bracket. Install two Pulleys (#23). Secure it with one M10 ×80 Hex Bolt (#43), twoWash- ers Dia10 (#39) and one M10 Nylon Nut (#38).
Pull the Cable over the top of the first Pulley (#23), Pull the Cable downward and attach a Pulley (#32) to it. Install the two Double Floating Pulley Brackets (#46) to the Pulley. Select any hole on the two Brackets for now. Secure them with one M10×45 Hex Bolt (#34), two Washers Dia10 (#39) and one M10 Nylon Nut (#38). After completing the installation, come back and adjust the tightness of the cable loop by selecting a different hole. Let the brackets hanging for now.
Draw the Cable upward to the second Pulley (#23). Thrill through above the Pulley (#32). Draw the Cable towards to the last bracket on the Upper Frame. Install a Pulley
(#33). Secure it with one M10 ×80 Hex Bolt (#43), two Washers Dia10 (#39) and one M10 Nylon Nut (#38). Draw the Cable around the Pulley then pull it down to the Slide Weight Holder (#10). Connect the Cable to the Holder and secure it with one Clip (#30).
Draw the end, without the rubber ball, of the 92”Low Row Cable (#16) to the opening at the upper of the Cross Brace (#04). Install a Pulley (#32) to the opening. Secure it with one M10 x 45 Allen Bolt (#34), two Washers Dia10 (#39) and one M10 Nylon Nut (#38). Draw the Cable underneath around the Pulley then pull upward to the Double Floating Pulley Brackets (#46). Install a Pulley (#32). Secure it with one M10 ×45 Allen Bolt (#34), twoWashers Dia10 (#39) and one M10 Nylon Nut (#38). Pull the Cable around the Pulley then downward to the bracket on the the Cross Brace (#04). Secure it with one Clip (#30).
9