JVC MX-G50 manual Connecting Speakers, To connect an outdoor AM antenna

AM antenna

1			2
ANTENNA			Vinyl-covered wire
			(not supplied)
FM [75	]	AM
	AM loop antenna
	(supplied)

1Press and hold the clamp of the AM terminals on the rear of the unit.

2Insert the end of the AM loop antenna cord into the terminal.

3Release the finger from the clamp.

4Turn the AM loop antenna until you have the best reception.

To connect an outdoor AM antenna

When reception is poor, connect a single vinyl-covered wire to the AM terminal and extend it horizontally. (The AM loop antenna must remain connected.)

Connecting Speakers

1			2
Speaker cord	Black			Speaker
(blue/black)				cord
MAIN SPEAKER		SUBWOOFER		(red/black)
[ 4-8	]		[6-16 ]
L			L
R			R
Blue	Black		Red
Speaker cord			Speaker cord
(blue/black)			(red/black)
From right			From right
main		subwoofer’s
speaker’s			terminals
terminals
From left				From left
main				subwoofer’s
speaker’s				terminals
terminals

1Press and hold the clamp of the speaker terminal on the rear of the unit.

2Insert the end of the speaker cord into the

terminal.

Match the polarity (colors): Blue (+) to blue (+) and black

(–)to black (–); Red (+) to red (+) and black (–) to black

(–).

For better reception of both FM and AM

•Make sure the antenna conductors do not touch any other terminals and connecting cords.

•Keep the antennas away from metallic parts of the unit, connecting cords, and the AC power cord.

3Release the finger from the clamp.

IMPORTANT: Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of the unit.

– 7 –