STEP 4 ASSEMBLE PEC DEC STATION
Attach PEC DEC SUPPORT(13) and PEC DEC PULLEY BRACKET(12) to PEC DEC UPRIGHT(2) using two 1/2" X 4" HEX HEAD BOLT(72) and two 1/2" NYLON NUT(86). Insert four 3/4" BUSHINGS(65) into PEC DEC SUPPORT(13).
Slide ADJ. CAM(14) onto the axle of RIGHT PEC DEC ARM BRACKET(16). Then thread the axle of RIGHT PEC DEC ARM BRACKET(16) through the hole on PEC DEC SUPPORT(13) and attach using 1/2" WASHER(89), 1/2" SPRING WASHER(92) and 1/2" NYLON NUT(86).
Tighten NYLON NUT(86) and back off approximately 1/2 tum so that arm moves freely. Repeat the same process to LEFT PEC DEC SET(17L).
Be certain the two ADJ. CAMS(14) are evenly seated on PEC DEC SUPPORT(13) and two PEC DEC ARMS(17) are WORKING SMOOTHLY before tighten with 1/2" WASHER (89), 1/2" SPRING WASHER(92) and 1/2" NYLON NUT(86).
Attach PEC DEC SEAT BAR(19) and CONNECTOR PLATE(11) to PEC DEC UPRIGHT
(2)using two 3/8" X 4" HEX HEAD BOLT(76), four 3/8" WASHER(90) and two 3/8" NYLON NUT(87).
86 | 93 |
| 86 |
92 |
| ||
|
| ||
89 | 72 | 19 | |
| 65 | ||
|
|
|
3213 
65 | 72 |
65 |
14
14
17R | 31 | 76 | 90 |
|
| ||
|
| 19 |
|
| 17L | 34 | 90 |
33 |
| 76 |
|
|
|
| |
56 |
|
|
|
33
5956
59
90
87
| 9116 89 | 93 | |
73 | 86 | ||
93 | 89 | 40 |
|
1717R
9