Platform Fold Pressure Adjustment
1.Position the platform at the floor level loading position.
2.Loosen the hex nut on the adjustment screw (do not remove hex nut).
3.Turn the adjustment screw counter clockwise until the platform does not fold when the Fold button is pressed.
4.Turn the adjustment screw clockwise in 1/4 turn increments and press the Fold button until the platform folds completely (Note: Return the platform to floor level position after each at- tempt to fold the platform).
5.Turn the adjustment screw an additional 1/8 turn after the platform folds successfully.
6.Tighten the hex nut without moving the adjust- ment screw.
7.Verify the platform will not stow while occupied.
Platform Fold |
Adjustment |
Allen Screw |
Note: Secure adjustment screw and tighten hex nut following adjustment.
Outer Barrier Fold Pressure Adjustment
1.Lower the platform to the ground level loading position.
2.Remove the pump cover.
3.Turn the adjustment screw (shown below) counter clockwise until the outer barrier does not raise when the Up button is pressed.
4.Turn the adjustment screw clockwise in 1/4 turn increments until the outer barrier raises and fully locks in position when the Up button is pressed. DO NOT turn the adjustment screw beyond this position.
5.Verify the outer barrier will not raise when occupied.
6.Reattach the pump cover.
Outer Barrier
Fold Adjustment
Allen Screw
Page 5