1.Attach the Front Stabilizer (2) to the front of the Frame (1) with two M8 x 70mm Carriage Bolts (72), two M8 Curved Washers (28), and two M8 Nylon Locknuts (56). Make sure that the Front Stabilizer is turned so the Roller (75) is not touching the floor.
2.Attach the Rear Stabilizer (3) to the rear of the Frame (1) with two M8 x 85mm Carriage Bolts (63), two M8 Curved Washers (28), and two M8 Nylon Locknuts (56).
3.While a second person holds the Upright (6) near the Frame (1), connect the Extension Wire Harness (18) to the Lower Wire Harness (44).
Carefully slide the Upright (6) onto the Frame (1). Be careful to avoid pinching the wires. Attach the Upright with four M8 x 15mm Button Screws (74) and four M8 Black Flat Washers (57). Important:
Make sure that the Upright is turned exactly as shown at the right.
5
1 |
|
|
|
72 | 75 | 2 |
|
|
| ||
|
| 28 | 56 |
|
|
| |
|
| 1 |
|
2 | 1 |
|
|
| 56 |
| |
|
|
| |
|
| 28 |
|
|
| 3 |
|
56 |
|
|
|
28 |
|
|
|
|
| 63 |
|
3 |
|
|
|
| 6 |
|
|
74 | 57 | Upright must | |
57 |
| be turned as | |
| shown |
| |
18 |
| 57 |
|
44 |
|
| |
|
|
| |
| 57 | 74 |
|
| 1 |
|
|