Assembly

To hire an authorized service technician to assemble the exercise cycle, call 1-800-445-2480.

Assembly requires two persons. Place all parts of the exercise cycle in a cleared area and remove the pack- ing materials. Do not dispose of the packing materials until assembly is completed. In addition to the included

hex keys, assembly requires a Phillips screwdriver and an adjustable wrench .

As you assemble the exercise cycle, use the drawings below to identify small parts. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the key number is the quantity needed for assembly. Note: Some small parts may have been pre- assembled. If a part is not in the hardware kit, check to see if it has been preassembled.

M6 Washer	M8 Split	M8 Nylon	M10 Nylon
(55)–8	Washer (59)–5	Locknut (60)–4	Locknut (63)–4
M4 x 16mm	M6 x 38mm Button		M6 x 42mm Button
Round Head	Screw (48)–4		Screw (49)–4
Screw (52)–4
M8 x 25mm Button		M8 x 70mm Button
	Screw (33)–3	Bolt (54)–2
	M10 x 75mm Carriage Bolt (51)–4