HOW to USE the Manual Mode

1Insert the key into the console.

See HOW TO TURN ON THE POWER on page 9.

Note: When you are familiar with the console, you may go directly to step 5. While learning to use the console, please read all steps.

2Select the MANUAL mode.

When the key is inserted, the MANUAL indicator

will begin to flash. (Note:

If a program has been selected, hold down the PAUSE/STOP button for

two seconds until the MANUAL indicator is flashing.) To select the manual mode, press the ENTER but- ton while the MANUAL indicator is flashing.

3Enter your weight if desired.

When the manual mode is selected, the TIME display will light and a weight setting will begin

to flash in the CALO- RIES/PULSE display. If

you enter your weight into the console, the CALO- RIES/PULSE display will be more accurate.

If you do not want to enter your weight, press the ENTER button. To enter your weight, press the SELECT buttons. Each time a button is pressed, the weight setting will change by 1 pound. If a but- ton is held down, the weight setting will change in increments of 5 pounds. When the correct weight is shown, press the ENTER button. Once your weight is entered, it will be saved in memory.

4Enter your age if desired.

After a weight setting is entered, an age setting will begin to flash in the SPEED display.

If you do not want to

enter your age, press the ENTER button. If you want to enter your age, press the SELECT but- tons. Each time a button is pressed, the age set- ting will change by 1 year. If a button is held down, the age setting will change in increments of 5 years. When the correct age is shown, press the ENTER button. Once your age is entered, it will be saved in memory.

5Press the START button or the SPEED + button.

A moment after the button is pressed, the walking belt will begin to move at 1.0 mph. Hold the hand- rails and begin walking. As you exercise, change the speed of the walking belt as desired with the SPEED buttons. Each

time a button is pressed, the speed will change by 0.1 mph. The speed range of the walking belt

is 0.5 mph to 10.0 mph.

To stop the walking belt for a moment, press the PAUSE/STOP button. The displays will pause and the TIME display will begin to flash. To restart the walking belt, press the START button or the SPEED + button. Note: To stop the walking belt and reset all displays, hold down the PAUSE/STOP button for two seconds. The console will then be in the same state as if the key had just been inserted.

Note: When one of the SPEED buttons is pressed, the SPEED display will show the selected speed setting for seven seconds. The display will then show the actual speed of the walking belt.

6Adjust the incline as desired.

To vary the intensity of your exercise, the in- cline of the treadmill can be changed with the

INCLINE buttons. Each time a button is pressed,

the incline will change by 0.5%. The incline range is 1.5% to 10%. Note: When one of the INCLINE buttons is pressed, the DISTANCE/INCLINE display will show the incline setting for seven seconds. After the INCLINE buttons are pressed, it may take a moment for the treadmill to reach the selected incline setting.

7Follow your progress with the LED displays.

TIME displayÑThis

display shows the total time that the walking belt has been moving.

Note: When a workout program is selected, this

display will show the time remaining in the program.