INSTALLATION OF PILOT
4.Secure the transmitter to the bike with two M4 x 40 screws; tighten with a 3 mm hex key.
5.Reinstall the transmitter battery cover and screw; tighten with a 2.5 mm hex key.
Checking the Installation:
1.Turn the console on by pressing START.
2.Rotate the cranks for 10 seconds and verify that the console is picking up the crank rotation and displaying RPM’s in the cadence section of the display window.
3.If you do not see RPMs in the display window, press the [CADENCE] key repeatedly until “INST” RPM is shown in the display window. If RPM still does not show, refer to the troubleshooting section of this manual.
Page 11