Milton Bradley 5844 manual Assembly, Setup, Gameplay, Winning, Restorage, Troubleshooting

Page 2

ASSEMBLY

The turtle legs are not inter- changeable. The initials on the underside of each leg identifies the slot that it fits into. Carefully snap the 4 legs into the openings on the underside of Topsy Turtle. See Figure 2 and Figure 2A.

SETUP

1. Place Topsy Turtle within reach of

all players.

2. Each player takes 2 of each colour

block (red, green and blue).

FR

FIGURE 2

SNAP 

LEGS 

IN

6.If Topsy falls over during your turn, you must gather all of the fallen blocks and add them to your pile.

7.Play continues until one player has placed all of his/her blocks under

Topsy’s feet.

NOTE: You can only use 1 hand to place a block, but if you’re quick, you may be able to place more than one block of the same colour under Topsy’s feet during the same turn. Also, if you think Topsy might topple, on your turn you may adjust the blocks under his feet to keep from falling. (Remember: Your turn ends when Topsy stops moving.)

Alternative Game (Cooperative): In this game, players work together to get Topsy Turtle to the top of all of the colour blocks. If he does fall, it’s up ok. Just put all the blocks back into a pile and begin again. When you get him on top of all of the blocks, everybody wins!

3. Keep your blocks within easy

reach and place any extra blocks

out of play.

GAMEPLAY

1. The youngest player goes first.

 

Play then proceeds to the left.

2.

Slide the ON/OFF switch located

 

on the underside of Topsy Turtle to

 

the ON position.

3.

After the short introduction, press

 

FIGURE 2A

REAR

REAR

RIGHT

LEFT

(RR)

(RL)

FRONT

FRONT

RIGHT

LEFT

(FR)

(FL)

LINE UP SLOTS TO SNAP EACH LEG

WINNING

The first player to place all of his/her blocks under Topsy’s feet wins. The winner then presses the raised scale and on Topsy’s back to hear his special winning message.

RESTORAGE

Carefully remove the legs from Topsy Turtle as shown in Figure 4. Return all contents to the box and close lid for easy storage.

FL

FIGURE 4

SNAP

LEGS 

OUT

the raised scale on Topsy’s shell to

begin play. See Figure 3.

4. Topsy calls out a colour, and

begins moving his legs up and

down. Insert a block of the colour

called under one of Topsy’s

raised feet. (For example: If Topsy

calls out “Blue,” place a blue

block under one of his raised

feet.) If Topsy calls out “Any

colour,” place any colour block

under one of Topsy’s feet.

5. When Topsy stops moving, your

turn is over.

INTO THE CORRECT HOLE

FIGURE 3

TROUBLESHOOTING

If Topsy’s head becomes detached, it can be reattached by pushing the clasp on the back of his head over the post in the neck opening of his shell, and snapping into place.

TO REPLACE BATTERIES

Make sure the ON/OFF switch on the electronic console is in the OFF position. Then loosen the screw on the battery

compartment, located on the underside of the console, and remove the door. Insert 4 AA-size batteries (we recommend alkaline), making sure to align the + and – symbols with the markings in the plastic. Replace the door and tighten the screw.

2

3

Image 2
Contents Contents ObjectTroubleshooting AssemblySetup Gameplay