JVC KX-KC15, MX-KC2 manual Mises en garde, précautions et indications diverses, For U.S.A

Page 2

Warnings, Cautions and Others /

Mises en garde, précautions et indications diverses

(For U.S.A)

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR BACK)

NO USER SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

The lightning flash with arrowhead symbol, within an equilateral triangle is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magni- tude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and mainte- nance (servicing) instructions in the literature accompanying the appliance.

INFORMATION

This equipment has been tested and found to com- ply with the limits for a Class B digital device, pursu- ant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communica- tions. However, there is no guarantee that interfer- ence will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is con- nected.

Consult the dealer or an experienced radio/TV technician for help.

WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

Note to CATV system installer:

This reminder is provided to call the CATV system installer’s attention to section 820-40 of the NEC which provides guidelines for proper grounding and, in partic- ular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.

For Canada/pour le Canada

CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.

PRECAUTION: POUR EVITER LES CHOCS ELECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQUAU FOND.

For Canada/pour le Canada

THIS DIGITAL APPARATUS DOES NOT EXCEED THE CLASS B LIMITS FOR RADIO NOISE EMISSIONS FROM DIGITAL APPARATUS AS SET OUT IN THE INTERFERENCE-CAUSING EQUIPMENT STANDARD ENTITLED “DIGITAL APPARATUS,” ICES-003 OF THE DEPARTMENT OF COMMUNICATIONS.

CET APPAREIL NUMERIQUE RESPECTE LES LIMITES DE BRUITS RADIOELECTRIQUES APPLICABLES AUX APPAREILS NUMERIQUES DE CLASSE B PRESCRITES DANS LA NORME

SUR LE MATERIEL BROUILLEUR: “APPAREILS NUMERIQUES”, NMB-003 EDICTEE PAR LE MINISTRE DES COMMUNICATIONS.

CAUTION –– % STANDBY/ON button !

ATTENTION –– Touche % STANDBY/ON

Disconnect the mains plug to shut the power off completely

Déconnectez la fiche de secteur pour mettre l’appareil

(all lamps and indications go off). The % STANDBY/ON

complètement hors tension (tous les témoins et toutes les

button in any position does not disconnect the mains line.

indications s’éteignent). La touche % STANDBY/ON dans

When the unit is on standby, the STANDBY lamp lights red.

n’importe quelle position ne déconnec-te pas l’appareil du

When the unit is turned on, the STANDBY lamp goes off.

secteur.

The power can be remote controlled.

Quand l’appareil est en mode d’attente, le témoin

 

STANDBY est al-lumé en rouge.

 

 

 

 

 

Quand l’appareil est sous tension, le témoin STANDBY

 

 

 

s’éteint.

 

 

L’alimentation ne peut pas être commandée à distance.

 

 

 

 

G-1

Image 2
Contents MX-KC2 Mises en garde, précautions et indications diverses For U.S.AClass 1 Laser Product Produit Laser Classe ’AVERTISSEMENT Placée À L’INTERIEUR DE L’APPAHow This Manual Is Organized FeaturesIntroduction Table of Contents Using the Remote Control AccessoriesHow To Put Batteries In the Remote Control Getting StartedUsing the Coaxial Type Connector Not supplied Connecting the FM AntennaUsing the Supplied Wire Antenna Rear Panel of the Unit Connecting the AM AntennaConnecting the Speakers Demo Mode Connecting External EquipmentConnecting to the Wall Outlet Compu PlayAdjusting the Volume Turning the Power On and OffECO Mode ECO Basic OperationsFade-out Muting Fade Muting Entering the Number with the Remote Control Numeric KeysSelecting the Sound Mode Reinforcing the Bass Sound Active Bass EXSelect a station using one of the following methods Using the TunerTuning In a Station One Touch RadioUsing the Unit Presetting StationsTo Change the FM Reception Mode Press the 4 or ¢ button to select the preset numberFor MP3 discs Using the CD PlayerWhen playing a CD-R or CD-RW More about MP3 discsOn the Remote Control only Changing the MP3 Playback ModeAbout Disc Indicator To Load CDs To Unload CDsTo Play CDs Basics of Using the CD Player- Normal PlayTo Select a Group For MP3 Group mode only To Select a TrackTo Play the Program You Have Made Programming the Playing Order of the TracksTo Make a Program To Exit and Re-enter Program PlayResume Play for MP3 Disc Random Play Tray Lock FunctionRepeating Tracks To Fast-Wind a Tape Using the Cassette Deck Listening to a TapePlaying a Tape Close the cassette holder gentlyTape a REC START/STOP Tape B Push Open Using the Cassette Deck RecordingThings To Know Before You Start Recording Program CD REC Start Dubbing Tape B Random Tape aCD Synchro Recording Standard RecordingTape to Tape Recording DUB- Bing To Record Any Sound Source to TapeAUX Using an External EquipmentListening to the External Equipment Fixing the Clock Using the TimersSetting the Clock Setting the on time Example AM Setting the Daily TimerSetting the OFF time Example PM Selecting the music sourceSetting the REC Recording Timer Turning the Daily Timer On and OffTurning the REC Recording Timer On and Off During playback a source, press the Sleep button Setting the Sleep TimerTimer Priority Wait for 5 secondsCare And Maintenance Troubleshooting Specification0305NYMCREBET