Spalding M890001 manual Safety Instructions

Page 2

NOTICE TO ASSEMBLERS

ALL basketball systems, including those used for DISPLAYS, MUST be assembled and ballasted with sand or water according to instructions. Failure to follow instructions could result in SERIOUS INJURY. It is NOT acceptable to devise a makeshift weight system.

IMPORTANT!

Remove all contents from boxes.

Be sure to check inside pole sections; hardware and additional parts are packed inside.

SAFETY INSTRUCTIONS

FAILURE TO FOLLOW THESE SAFETY INSTRUCTIONS MAY

RESULT IN SERIOUS INJURY,

PROPERTY DAMAGE AND WILL VOID WARRANTY.

This unit is intended for display purposes only and

should not be used for play.

To ensure safety, do not attempt to assemble this system without following the instructions carefully. Check entire box and inside all packing material for parts. Before beginning assembly, read the instructions and identify parts in this document. Proper and complete assembly, use and supervision is essential for proper operation and to reduce the risk of accident or injury. A high probability of serious injury exists if this system is not installed, maintained, and operated properly.

During assembly, if using a ladder use extreme caution. Two capable adults are recommended for this operation.

If technical assistance is required, contact the Sample and Display Technician.

Serious injury could occur if teeth/face come in contact with backboard, net or rim.

Display recommended for 3” (7.6 cm) or 3-1/2” (9 cm) Round or 4” (10 cm) Square poles only.

All instructions and warnings MUST accompany any display item that is sold.

Most injuries are caused by misuse and/or not following

instructions. Use caution when installing this unit.

ID# M890001

09/06

2

Image 2
Contents Display System Safety Instructions Parts List See Hardware Identifier Hardware Identifier Nuts, Washers & SpringsDisplay Stand Top View ID# Corner Location 1 Steel Frame Acrylic Backboard Assembly Acrylic Corner Location 2 48 FAN Molded Plastic Board Assembly Tighten nut 17 until Corner Location 3 44 FAN Molded Plastic Board Assembly Corner Location 4 44 FAN Molded Plastic Board Assembly