Raise Tent, Attach Rainfly | Coleman 9271-210 specification

3 Raise Tent

–Assemble center shock-corded brace poles (longer poles).

–Insert square end of brace poles into curved roof poles and raise tent upright. (illus. 5, 6)

–Brace poles should attach to squeeze pins at bottom of tent. (illus 7)

–Assemble end (shorter) shock-corded brace poles.

Brace pole

Curved

poles in pole

sleeve

illus. 5 When attaching the brace poles to the curved poles make sure that the brace poles naturally point straight down.

Grommets for

rainfly pole

End brace pole

–Insert end brace poles into end roof assemblies. MAKE SURE when attaching the brace poles to the curved poles that the bottom of the brace pole naturally points down and toward the center of the tent. (illus. 9)

–Brace poles attach to squeeze pins at edge of tent. (illus. 8)

Center brace pole	illus. 6
	Shown with center brace
illus. 7	poles and end brace poles
	in position.
Insert squeeze
pin into pole

4 Attach Rainfly

–Assemble rainfly poles,by interlocking shock-corded poles.

–Insert rainfly pole through the pole sleeves located at the center edges of the underside of rainfly. (illus. 8)

–Drape rainfly over tent frame, pole side down. rainfly poles go over door and rear window and attach “S” hooks on rainfly into holes in brace poles. (illus. 11)

–Secure rainfly with hook & loop fasteners located on underside of fly. (illus. 9)

–Insert tip of rainfly pole into the grommet on the front of the tent and gently arch the pole until you

can insert the opposite end in the other grommet.. Repeat for back

side of tent. (illus. 6 & 9)

–Stake out rainfly ends using included guylines. (illus. 10)

illus. 8

Rainfly poles through pole sleeves

Rainfly pole inserts into grommets on tent

illus. 9 Tent shown completely set-up.

Brace pole with hole for rainfly “S” hook

illus. 10 Stake out rainfly

ends. Slide the disc up the rope to tighten

guyline.

Things You Should Know

•Under certain conditions (cold weather, high humidity, etc.)

condensation will form on the inside surfaces of your tent. Condensation is caused by water vapor from your breath, perspiration, or any wet clothing inside your tent. It is NOT LEAKAGE through the tent fabric. It can be minimized by removing wet clothing from your tent and by providing good ventilation through the tent.

•Never store tent, even for a short period of time, without drying it thoroughly and brushing off caked dirt. Do not pack stakes or poles inside your tent. Use a separate storage bag.

•STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF. NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO REMOVE STAKE.

•TENT POLES SHOULD NOT BE LEFT TELESCOPED

TOGETHER DURING STORAGE.

•Seam sealer has not been provided with your tent. We recommend seam sealing your tent prior to camping. Seam sealer may be purchased through your local retailer or at your local sporting goods store.

PRINTED IN SRI LANKA Rev. 12/03

•Do not leave your tent set-up for weeks at a time, be aware that exposure to the ultraviolet rays of the sun can seriously damage material and/or cause it to become discolored.

WARNING: KEEP ALL FLAME AND HEAT SOURCES

AWAY FROM THIS TENT FABRIC. This tent meets the flammability requirements of CPAI-84.The fabric will burn if left in continuous contact with any flame source.The application of any foreign substance to the tent fabric may render the flame-resistant properties ineffective.

THE COLEMAN CO., INC.

3600 N. Hydraulic • Wichita, Kansas 67219

1-800-835-3278 • www.coleman.com

MADE IN SRI LANKA