Coleman 2000002250 manual Cabin Tent 13’ X 9’ Model, Before you begin, To Set Up Tent

CABIN TENT 13’ X 9’ MODEL 2000002250

STITCH LINE

Before you begin

Read all instructions before set up.

•Select a level site clear of rocks, branches, and other hard or sharp objects, to install your tent.

WARNING: Keep clear of overhead power lines.

•Do not set up your tent under trees because of potential lightning strikes or falling tree limbs in inclement weather.

•Secure with all stakes and guylines provided to prevent property damage or personal injury.

•For best results in windy conditions, position narrow end of tent into the wind.

•Enlist the help of at least one other person to assist you when it is time to assemble the tent.

Pole Descriptions

Description	Qty.	Pole	Pole	Pole
		Dia.	Repair Kit	Replacement Kit
Leg Pole, metal	4	19mm	N/A	5010000650
Leg Pole, metal,
with white marking	2	19mm	N/A	5010000651
Top Pole, thick, grey,	1	12.7mm	5010000538	5010000550
Top Pole, thick, black	2	12.7mm	5010000538	5010000550
Door Pole, long, thin, black,
fiberglass, rubber tips	1	6.3mm	5010000543	5010000545
Vert. Door Pole, short, black,
fiberglass, rubber tips	1	6.3mm	5010000543	5010000545

To Set Up Tent

1.Unfold tent and spread out on a clean, level surface with the

door facing the desired direction. (Fig. 1)

2. Assemble all fiberglass and metal poles by interlocking the shock-corded, sections together.

3. Insert thick, black, Top Poles through the sleeves on top of tent forming an X”; then push end of each pole into black Pole Connector to form an arch. (Fig. 1 & 1A)

4. Insert thick, grey Top Pole through the grey trimmed center sleeve, running from the front to the back of tent; then push end of pole into black Pole Connector to form an arch.

(Fig. 1 & 1B)

5.Insert four metal Leg Poles into end of Pole Connectors at the four corners of the tent. (Fig. 1 & 1C)

NOTE: Make sure end with metal “V” spring is inserted into Pole Connector.

6.Insert two metal Leg Poles (with white markings) into end of Pole Connectors at front & back of the tent. (Fig. 1 & 1C) NOTE: Make sure end with metal “C” spring is inserted into Pole Connector.

Pole		Pole
Connector		Connector
1A	Metal Leg Poles	1B
	Metal Leg Pole with
	White Marking
Metal Leg Pole
		Metal Leg Pole
	Door & Front of Tent
	Metal Leg Pole with
	White Marking
		Fig. 1

“C” Spring

1C

7.Rotate metal Leg Poles to upright position; then insert metal pin on web strap at front, back, & four corners of tent into bottom of each pole. (Fig. 2 & 2A)

NOTE: You can use the tri-glide to adjust the length of the center webbing to make it easier to insert the metal pin into the metal center pole.

8.Snap large frame clips on seams of tent onto metal Leg Poles to secure. (Fig. 2 & 2B)

9.Stretch four corners of tent until taut; then drive metal stake through ring on web strap of each to secure (Fig. 2 & 2C).

10.Stretch web strap at front & back of tent until taut; then drive metal stake through ring on each to secure (Fig. 2 & 2C).

Fig. 2

2A

Tri-Glide

2C

2B

Hinged, Rigid Door

1.	Insert Vertical Door Pole (shorter black
	pole with plastic cap tips) through zippered
	vertical sleeve on hinged side of door.
	(Fig. 3)
2.	Insert end of Vertical Door Pole into bottom
	hinge plate, apply pressure to form a slight
			Pole
	bow, then insert other tip of pole into top		Sleeve
	hinge (Fig. 4). Zip up vertical pole sleeve.
3.	Insert Door Pole (long, black pole with
	plastic cap tips) into zippered pole sleeve
			Fig. 3
	at top of door. (Fig. 5)
4.	Insert end of Door Pole into top hinge		Fig. 4
	plate, apply pressure to form a bow, then
	insert other tip of pole into the bottom
	hinge. (Fig. 6)
5.	Zip up “C” shaped pole sleeve to
	enclose Door Pole. (Fig. 7)		Fig. 5
		Pole Sleeve

Fig. 7 Fig. 6

To Attach Rainfly

1.Drape Rainfly over tent with the triangle-shaped leg flaps with elastic cords centered over the four corner of the tent. (See Fig. 8 on other side of this tag).

NOTE: Hook and loop fasteners, located on seams of under side of rainfly, should be centered over the Leg Poles.

(continued on other side)