To Attach Rainfly (continued)
Fig. 8 |
| |
| Rainfly | Leg Cover |
|
| |
|
| Door |
|
| Front of Tent |
Attaching Room Divider & Overhead Storage Panel
1.Divider Panel can be installed through center of the tent by insert- ing the toggles through top and bottom fabric loops as shown. (Fig. 12 & 12A)
2.Install the Overhead Storage Panel by inserting the toggles through the fabric loops at the top of the tent.
Fig. 12
Overhead
Storage
Panel
Zippered
Divider
Panel
12A
Top
Fabric
Loops
2.Locate all hook & loop fasteners on underside of Rainfly and Leg Covers; then wrap around four corner and front and back Leg Poles to secure. (Fig. 9, 9A, & 9B)
3.Stretch elastic straps and hook clip on each to the metal loops at the four corners of the tent at the bottom of the Leg Poles. (Fig. 9 & 9C)
4.Stretch elastic straps above center front and back leg; then hook onto metal ring on Leg Pole. (Fig. 9 & 9D)
5.Stretch all guylines until taut, then secure with stakes. (Fig. 9 & 9E)
9A | 9B |
9C
Door
| 9D | |||
|
|
|
| Fig. 9 |
|
|
|
|
|
9E |
|
|
|
|
|
|
|
| |
|
|
|
|
|
Electrical Cord Access |
| Fig. 10 |
|
|
|
|
|
| |
1.Unzip access panel in the lower left front corner of tent and bring in electrical cord. Use only UL approved cords that are rated for outdoor usage. (Fig. 10)
Cooler Access
The smaller zippered opening at the back of tent is designed for added ventilation and easy access to your beverage cooler.
1.To use as a cooler access, unzip other flap to make an avenue to bring beverages into tent. (Fig. 11)
2.To use as a vent, unzip flap to expose screen.
Fig. 11
To Store
1.All poles and stakes must be placed in the storage bag to prevent damage to the fabric items placed in the carry case.
2.Make sure tent is clean and dry before placing in carry case.
3.Remove rainfly, spread out on floor of tent, then unzip door & vents before taking tent down for storage.
4.Neatly fold tent to width of pole storage bag, place on tent, roll tightly, and place in carry case.
5.Store in a clean, dry area.
Things You Should Know:
•Under certain conditions (cold weather, high humidity, etc.) condensa- tion will form on the inside of your tent. Condensation is caused by water vapor from your breath, perspiration, or any wet clothing inside the tent. It is NOT LEAKAGE through the tent fabric. It can be minimized by removing wet clothing from your tent and by providing good ventila- tion through the tent.
•Tree limbs, tree sap, bird droppings, or moisture steadily dripping off tree limbs can cause damage to the tent fabric and its coating resulting in leaks or loss of
•Never store tent, even for a short period of time, without drying it thoroughly and brushing off caked dirt. Do not pack stakes or poles inside your tent. Use a separate storage bag.
•Stakes should be removed by pulling on the stake itself. NEVER PULL ON THE TENT TO REMOVE STAKES AS THIS COULD RESULT IN PROPERTY DAMAGE OR PERSONAL INJURY.
•Tent poles should not be left telescoped together during storage.
•Do not leave your tent
WARNING: Keep all flame and heat sources away from this tent fabric.
This tent meets the flammability requirements of
The Coleman Company, Inc. • 3600 N. Hydraulic • Wichita, Kansas 67219
MADE IN BANGLADESH • PRINTED IN BANGLADESH
© 2009 The Coleman Company, Inc.
Coleman®, 
, and 
are registered trademarks of
The Coleman Company, Inc.
4010004270 (20090226)
STITCH LINE