Coleman 2000002120 manual Rear Vent Flap, Front Door Flap, To Secure Beach Shade in Sandy Terrain

Page 2

To Set Up Beach Shelter (continued)

11.Attach guy lines to the front of the Beach Shade, above the large door, by

inserting the guy line through the webbing between the grommet and the shade material. (Fig. 9)

Fig. 9

12.Extend guy lines out until taut then secure with stakes. (Fig. 10 & 11)

Fig. 10

Fig. 11

NOTE: Use cord located above front door of the Beach Shade as a dry line.

Rear Vent Flap

The rear flap of the Beach Shade may be raised and lowered to allow for better ventilation, improve lighting, or privacy.

1.Unzip inside flap to expose mess screen for ventilation.

2.Roll flap up and secure by inserting both dowels through loops. (Fig. 12)

Loops &

Dowels

Fig. 12

3.Undo outer zipper on rear vent flap and roll up for ventilation or additional access to Beach Shade.

4.Roll flap up and secure by inserting both dowels through loops. (Fig. 13)

Loops &

Dowels

Fig. 13

Front Door Flap

For additional privacy, the front panel (door) of the Beach Shade is equipped with a zippered closure.

To Secure Beach Shade in Sandy Terrain

1.Fill the (6) sand bags with sand or small rocks. (Fig. 14)

2.Insert the toggle of the filled sandbag through the grommet on the stake loop where the stake would have been. (Fig. 15)

3.Bury the sand bag to secure the Beach Shade.

4.Tie the end of the guy line to the sand bag, extend and bury. Repeat for second guy line.

 

 

 

 

 

Fig. 14

 

 

Fig. 15

 

 

 

 

 

 

 

 

 

 

 

To Store

1.All poles and metal stakes must to be placed in the storage bag to prevent damage to the fabric items placed in the carry case.

2.Make sure Beach Shade is clean and dry before placing in carry case.

3.Neatly fold Beach Shade to width of pole storage bag. Place storage bag on folded Beach Shade, roll tightly, and place in carry case.

4.Store in a clean, dry area.

Things You Should Know:

Under certain conditions (cold weather, high humidity, etc.) condensa- tion will form on the inside of your shelter. Condensation is caused

by water vapor from your breath, perspiration, or any wet clothing inside the shelter. It is NOT LEAKAGE through the shelter fabric. It can be minimized by removing wet clothing from your shelter and by providing good ventilation through the shelter.

Tree limbs, tree sap, bird droppings, or moisture steadily dripping off tree limbs can cause damage to the shelter fabric and its coating resulting in leaks or loss of flame-resistant properties.

Never store shelter even for a short period of time, without drying

it thoroughly and brushing off caked dirt. Do not pack stakes or poles inside your shelter. Use a separate storage bag.

Stakes should be removed by pulling on the stake itself. NEVER PULL ON THE SHELTER TO REMOVE STAKES AS THIS COULD RESULT IN PROPERTY DAMAGE OR PERSONAL INJURY.

Shelter poles should not be left telescoped together during storage.

Do not leave your shelter set-up for weeks at a time. Be aware that exposure to ultraviolet rays from the sun can seriously damage material and/or cause it to become discolored.

WARNING: Keep all flame and heat sources away from this tent fabric.

This tent meets the flammability requirements of CPAI-84. The fabric may burn if left in continuous contact with any flame source. The application of any foreign substance to the tent fabric may render the flame-resistant properties ineffective.

The Coleman Company, Inc. • 3600 N. Hydraulic • Wichita, Kansas 67219

1-800-835-3278 • www.coleman.com

MADE IN BANGLADESH • PRINTED IN BANGLADESH

© 2008 The Coleman Company, Inc.

Coleman®, , and are registered trademarks of The Coleman Company, Inc.

4010004156 (20081104)

STITCH LINE

Image 2
Contents Before you begin To Set Up Beach ShadeTo Set Up Beach Shelter To Secure Beach Shade in Sandy Terrain Rear Vent FlapFront Door Flap To Store