Before you begin, To Set Up Tent | Coleman 2000001973 instruction

Before you begin

•Select a level site clear of rocks, branches, and other hard or sharp objects, to install your tent.

WARNING: Keep clear of overhead power lines.

•Do not set up your tent under trees because of potential lightning strikes or falling tree limbs in inclement weather.

•Secure with all stakes and guylines provided to prevent property damage or personal injury.

•For best results in windy conditions, position narrow end of tent into the wind.

•Enlist the help of at least one other person to assist you when it is time to assemble the tent.

STITCH LINE

To Set Up Tent			Fig. 1
1.	Unfold tent and spread out on a clean,	Long, Black,
	level surface with the door facing the	Shock-corded
	desired direction. (Fig. 1)	Main Poles
	desired direction. (Fig. 1)
2.	Assemble two main tent poles by inter-
	locking the longer, black shock-corded,
	poles.
3.	Insert both, long, black poles through
	sleeves in top of tent as shown. (Fig. 1)

		Door

4.Insert one end of each black pole into pins in front corners of tent.

(Fig. 2)

5.Go to opposite end of each pole and gradually apply pressure to the pole forming an arch. Insert

6.Attach frame clips along edges of tent to black main poles. (Fig. 3A)

7.Stretch corners and sides of tent until floor is taut

then hammer stakes through loops to secure. (Fig. 3B)

Fig. 3

1.Assemble the black interlocking shock-corded ridge pole with rubber tips.

2.Unfold rainfly. Locate the web pockets on front and back of rainfly, and the hook & loop fasteners on the underside of rainfly.

3.Insert rubber-tipped ends of ridge pole into web pockets located

on both sides of underside of the rainfly. (Fig. 4)

4. Locate hook & loop fasteners on the rainfly4A and wrap around black ridge pole to secure.

(Fig. 4A)

Black Ridge

Pole

(continued on other side)

Web

Pocket

Black Ridge Pole

Fig. 4