JVC FS-V100 manual Setting the Sleep Timer, Insert a blank or erasable tape into the Cassette Deck

7Press the ¢ or 4 button until “TUNER” appears and the REC indicator lights up on the display.

The display changes as shown below.

8Set the volume level.

1.Press the TIMER button on the Unit.

The current volume setting flashes on the display.

2.Press the ¢or 4button to select the volume level.

-- : The current volume level will be used.

0 to 40 : When the timer is turned on, the volume will be automatically set to the selected level.

To turn off the volume while the Recording Timer is

working, set the volume level to “0.”

9Press the TIMER button on the Unit.

The timer setting is completed and the display returns to the indications before you set the timer. The Timer indicator remains lit.

Note: If you change the station before turning off the System, the last received station will be recorded.

10 Insert a blank or erasable tape into the Cassette Deck.

•Make sure that the tape has the enough length for recording.

11 Press the POWER button to turn off the System.

To cancel the timer, press the TIMER button for more than 2 seconds. The REC and Timer indicators go out on the display.

To re-activate the canceled timer, press the TIMER button for more than 2 seconds to light the REC and Timer indicators.

To confirm the timer settings, cancel the timer once by pressing the TIMER button, and press the button again for more than 2 seconds. Then, press the TIMER button repeatedly, to see the current timer settings (ON time, OFF time, source, and volume). Press the TIMER button to set the timer again.

To change the timer setting, repeat the setting procedure from the beginning.

•When the timer turns on, the Timer indicator starts flashing.

Note: If the Unit is turned on when the timer-on time comes, Recording Timer does not work.

CAUTION:

If the System is unplugged, or a power failure occurs, the timer will be canceled. You will need to reset the clock first, then the timer.

Setting the Sleep Timer

When a source is playing, use the Sleep Timer to turn the System off after a certain number of minutes. By setting the Sleep Timer, you can fall asleep to music and know that your System will turn off by itself rather than play all night.

■You can only set the Sleep Timer when the System is on.

Note: The clock must be correctly set for the timers to work. If the clock has not been set, the CLOCK indicator will flash on the display when you press the TIMER button for more than 2 seconds, and then the display alternates between “ADJUST” and “CLOCK” for about 5 seconds.

1Play a CD or a cassette tape, or tune in to the desired station.

2Press the SLEEP button on the Remote Control.

The SLEEP indicator lights up.

3Set the length of time you want the source to play before shutting off.

•Each time you press the SLEEP button, it changes the number of minutes shown on the display in this sequence:

10 20 30 60

Canceled 120 90

After setting the number of minutes for the Sleep Timer, the display will stop flashing and return to the previous state.

The System is now set to turn off after the number of minutes you set.

To confirm the Sleep Time

When the SLEEP button is pressed, the remaining sleep time is displayed.

To cancel the Sleep Timer setting

Press the SLEEP button until the SLEEP indicator goes out on the display.

Turning off the System also cancels the Sleep Timer.

19

EN10-22.FS-V100[J]f 19 12/12/00, 10:33 AM