JVC MX-GT70 manual Using Recording Timer, Select the preset station, If necessary

Page 26

Using Recording Timer

With Recording Timer, you can make a tape of a radio broadcast automatically. You can set the timer whether the system is on or off.

How Recording Timer actually works

The unit automatically turns on, tunes into the specified station, sets the volume level to “MIN,” and starts recording

when the on-time comes (the indicator flashes just before the on-time, and continues flashing while the timer is operating). Then, when the off-time comes (“OFF” appears just before the off-time), the unit automatically turns off (on standby).

The timer setting remains in memory until you change it.

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

•To correct a mis-entry while setting the timer, press

CANCEL/DEMO.

On the unit ONLY:

1 Put a recordable cassette into deck B.

2 Press CLOCK/TIMER repeatedly until “REC” appears on the display.

The REC (Recording Timer) indicator also starts flashing on the display.

•Each time you press the button, the timer setting modes change as follows:

DAILY ON TIME REC

Canceled Clock ON TIME setting

(See page 9.)

3 Press CLOCK/TIMER again.

“ON TIME” appears for 2 seconds, then the unit enters on-time setting mode.

4 Set the on-time you want the unit to turn on at.

1) Turn 4/ ¢ to set the hour, then press SET/DISPLAY.

2)Turn 4/ ¢to set the minute, then press SET/DISPLAY.

“OFF TIME” appears for 2 seconds, then the unit enters off-

time setting mode.

5 Set the off-time you want the unit to turn off (on standby) at.

1)Turn 4/ ¢ to set the hour, then press

SET/DISPLAY.

2)Turn 4/ ¢ to set the minute, then press

SET/DISPLAY.

The unit enters preset station selecting mode.

6 Select the preset station.

1)Turn 4/ ¢to select the band (“TUNER FM” or “TUNER AM”), then press SET/DISPLAY.

2)Turn 4/ ¢ to select a preset channel number, then press SET/DISPLAY.

The REC (Recording Timer) indicator stops flashing and remains lit. The settings you have done are shown on the display in sequence.

7 Press STANDBY/ON

to

STANDBY/ON

turn off the unit (on standby)

STANDBY

if necessary.

 

 

If you want to listen to another source while recording

Press REC START/STOP or 7to stop recording. Without stopping it, you cannot change the source.

Even if you unplug the AC power cord or if a power failure occurs

Once you set the timer, the timer setting may remain stored in memory in a few days. In this case, check whether the timer setting still remains or not.

– 23 –

Page 25 Page 27
Image 26
Page 25 Page 27
Contents MX-G70 Mises en garde, précautions et indications diverses Instructions for safe use About This Manual PrecautionsIntroduction Contents Front Panel Location of the Buttons and ControlsFront Panel Become familiar with the buttons and controls on your unitAUX button and lamp Display WindowSee pages in the parentheses for details 0Disc tray open/close CD1, CD2, and CD3 buttons 13, 14Disc number buttons CD1, CD2, and CD3 14 Remote ControlRemote Control CD 3´8button 9, 14Getting Started Supplied Accessories Connecting AntennasPutting the Batteries into the Remote Control FM antennaAM antenna Connecting SpeakersTurn the AM loop antenna until you have the best reception To connect an outdoor AM antennaClose the speaker terminals Connecting Other EquipmentCanceling the display demonstration On the unit onlyCommon Operations Turning On or Off the PowerSetting the Clock Selecting the SourcesReinforcing the Bass Sound Adjusting the VolumeTo turn down the volume level temporarily Selecting the Sound ModesTo use your own sound mode Creating Your Own Sound Mode Manual ModeOn the unit only Select one of the preset sound modes Tuning in a Preset Station Tuning in a StationPresetting Stations Listening to FM and AM BroadcastsPress the same 0 you have pressed in step Playing Back CDs CD/CD-R/CD-RWLoading CDs Repeat steps 1 to 3 to place other CDsPlaying Back the Entire Discs Continuous Play Basic CD OperationsProgram Play Prohibiting Disc Ejection Tray Lock Playing at Random Random PlayRepeating Tracks or CDs Repeat Play To exit from Random play mode, press Random againLocating the Beginning of a Song Music Scan Playing Back TapesPlaying Back a Tape Recording a Tape on Deck B To clean the heads, capstans, and pinch rollersRecording To protect your recordingCD Direct Recording To record on both sides Reverse ModeDubbing Tapes Press DubbingAuto Edit Recording Press CLOCK/TIMER again Using the TimersUsing Daily Timer How Daily Timer actually worksTurn 4/ ¢to set the volume level When selecting Tuner FM or Tuner AMWhen selecting CD Press SET/DISPLAY to complete the Daily Timer settingHow Recording Timer actually works Using Recording TimerSelect the preset station Unit enters preset station selecting modeOn the remote control only Press Sleep Using Sleep TimerTimer Priority Wait for about 5 seconds after specifying the time lengthTo clean the disc MaintenanceCleaning the unit Handling discsTroubleshooting SymptomSpecifications Speaker section SP-MXG70 MX-G70Amplifier section CA-MXG70 HOW to Locate Your JVC Service Center Limited Warranty AUDIO-1 0101MWMMDWJEM

MX-GT70 specifications

The JVC MX-GT70 is a powerful and versatile audio system that stands out for its impressive features and modern technologies, making it a top choice for music enthusiasts. This speaker system, which combines functionality with an eye-catching design, offers a unique blend of performance and style.

One of the main features of the JVC MX-GT70 is its high-performance speakers. The system is designed to deliver robust audio quality, with exceptional clarity and depth. Boasting an impressive output power, it can fill a room with sound, making it ideal for parties and gatherings. The system effectively reproduces a wide range of frequencies, ensuring that bass sounds are deep and powerful while highs are crisp and clear.

The MX-GT70 also incorporates advanced audio technologies, including JVC's proprietary Dynamic Bass Boost. This feature enhances low frequencies, providing an extra layer of punch to your music. Whether you are listening to hip-hop, electronic, or any genre that benefits from bass, the Dynamic Bass Boost ensures that you feel the rhythm. Additionally, the system supports various audio formats, including MP3 and WMA, allowing you to enjoy your favorite tracks in multiple ways.

Connectivity is another strong suit of the JVC MX-GT70. It offers multiple input options, including USB, AUX, and Bluetooth, facilitating seamless integration with various devices. Bluetooth connectivity gives users the flexibility to play music wirelessly from smartphones, tablets, and laptops, promoting convenience without compromising sound quality.

The JVC MX-GT70 also features an intuitive control panel, making navigation through tracks and settings straightforward. The LCD display provides clear information on the current track, volume levels, and system settings, enhancing user experience.

Moreover, the design of the MX-GT70 is aesthetically pleasing, with a modern yet robust look that ensures it fits well in any environment. Its compact size allows for easy placement, while the build quality ensures durability.

In summary, the JVC MX-GT70 stands out for its powerful audio performance, advanced technologies, and user-friendly features. With its impressive connectivity options and striking design, it not only meets the needs of audio enthusiasts but also enhances their overall music experience. Whether for casual listening or lively parties, the MX-GT70 delivers a high-quality sound that truly impresses.
Top Page Image Contents