Charge your product, LED status | Epson PS-100 instruction

Pulsense™ PS-100

Quick Start

Read these instructions before using your product.

Charge your product

Before using your product for the first time, make sure the battery is fully charged. Charging takes approximately 1.5 to 2.5 hours. A full charge lasts about 36 hours.

Caution: Do not attach the charging cradle when the PS-100 is wet. If the PS-100 is wet, wipe it with a damp cloth, remove the moisture with a towel, then let it air dry before attaching the charging cradle.

1.Center the PS-100 under the large tab, then press down until it clicks into place.

2.Insert the USB plug into a power source. You can use:

■Computer (USB is for charging only, not for data transfer)

■Optional USB AC Adapter (part number SFAC04)

The orange LED lights up when your PS-100 is connected correctly. Charging is complete when the blue LED is lit.

BlueOrange

To remove your PS-100 from the charging cradle, press the small tab down and push the PS-100 out from the back.

Install Epson PULSENSE View

Download Epson PULSENSE View from your mobile device’s app store.

The following mobile devices are supported:

■iPhone 4s, iPhone 5, iPhone 5c, or iPhone 5s with iOS 7.1 or later

■Mobile device running AndroidTM 4.3 or later with Bluetooth® Smart

3.Follow the on-screen instructions to pair your PS-100 with your mobile device and perform the initial configuration.

The PS-100 can store up to 480 hours of data before needing to be synced.

App icon Meaning

No network connection. Make sure you have a network or data connection, then tap the icon to reconnect.

No Bluetooth connection. Make sure Bluetooth is enabled on your product and mobile device, then tap the icon to reconnect.

LED status

The LEDs on the PS-100 light up or flash to indicate different states. When exercising, the LEDs indicate which zone you’re currently in. The PS-100 vibrates when entering or leaving a zone.

Light pattern	Status

	Heart rate is below the fat burning
	zone

	Heart rate is approaching the fat
	burning zone

	Heart rate is in the fat burning zone

	Heart rate is in the aerobic exercise
	zone

	Heart rate is in the anaerobic
	exercise zone

	Heart rate is above the anaerobic
	exercise zone (flashing rapidly)

	The battery is low

	Airplane mode

Wearing your PS-100

Follow these steps to adjust the wristband:

1. Unfasten the buckle of the wristband.

2.Unhook the band and adjust it to fit your wrist. Keep these tips in mind when wearing your PS-100:

■The Pulsense band needs to be worn snugly around the wrist to collect more accurate heart rate data. This may cause a slight impression on the wrist. Adjust the band for the comfort and performance you choose.

■When wearing the PS-100, make sure it does not touch the ulna bone.

Ulna bone

■For greater accuracy, wear the Pulsense band on your non-dominant wrist.

■Before boarding an aircraft, put your PS-100 in airplane mode by repeatedly tapping the top of the band.

Launch the app and pair your PS-100

You must pair your PS-100 through the Epson PULSENSE View app. The PS-100 will not store any data until you’ve paired it with the app.

Follow these steps:

1.Start the Epson PULSENSE View app.

2.Make sure that the PS-100 is within 3 feet (1 meter) of the mobile device.

Calibrating your heart rate

To personalize your heart rate zones and calibrate the sleep monitoring feature, wear your PS-100 for 2 to 7 days while you sleep. The accuracy of your heart rate zone and sleep data will improve after the PS-100 has calibrated your resting heart rate.