,1_Ra_sethe back end of the eX_mise bike. Attach the Stabilizer (13)
_. ,..::
"_:_ • _ | are on the stde shown! | Lo_et the exercise bike. : : .... | " " | |
I | " " | ' | '/! |
|
i
2.Slide the free end of the Roller Axle (42) through the Bushings
(43)in the Frame (11). Press the unattached Roller (24) onto the end of the Axle. It may be helpful to tap the Roller with a hammer
in o,'derto press it fully onto the Axle.
13
2
24
11
42
3. Remove the four 1/4" Seat Nuts (7) from the underside of the | 3 | |
Seat (5). Remove the Seat Post (6) from the Frame (11). Attach | ||
| ||
the Beat to the top of the Seat Post with the four 1/4" Seat Nuts. |
| |
Insert the Seat Post (6) into the Frame it 1), adjust the Seat (5) to |
| |
the desired height, and ir_sertthe Seat Pin (8) through the front of |
| |
the Frame and the Seat Post. Slide the Seat Post Collar (30) |
| |
down over the Frame. CAUTION: At least two inches of the |
| |
Seat Post must be inside of the Frame. The Seat Pin must be |
| |
inserted from the front, as shown. If the Seat Pin is inserted |
| |
from the back, it may slip out, resulting in injury. |
|
4.Connect the wire protruding from the Console Mount (2) to the Wire Harness (66) (see the inset drawing). Make sure that the wire is turned so it fits easily into the Wire Harness. If the wire is not turned correctly and is forced into lhe Wire Harness, the Console (1) will not function properly.
Slide the Console Mount (2) onto the Frame (11). CAUTION: Be careful to avoid pinching your fingers or the Wire Harness
(66). Attach the Console Mount to the Frame with the two 5/16" x 1/;_"Screws (33).
6
Wire
R